The Experimental Study of Ion Exchange Resin Wears in the Process of Transferring Between Devices

LIU Qing,LEI Ze-yong
DOI: https://doi.org/10.3969/j.issn.1000-8063.2012.02.006
2012-01-01
Abstract:According to the problem of resin wear in the process of conveying,an experimental device was processed.The relationship between the diameter of pipe in which the resin was transferred,the water flow rate and the wear of resin in the process of transferring was investigated,the wear volume and wear rate after 100 times transferred were measured,and the factors that affected the resin wear were analyzed.It is observed that when the diameter of the pipe is large(such as Ф100 mm) in the transportation,the air in the pipe interfered the transfer of the resin,and the amount of resin wear increased;when the resin was transferred in a smaller pipe which contained fewer air,in the same flow rate of water,the smaller the connection pipe diameter is,the more crowded the resins are in the connection pipe,the friction between each other is more intensive,the contact between resin and pipe wall is more serious,the resin wear is also more obvious.In the same connection pipe diameter,the greater the fluid flow is,the greater the velocity is,the collision between resin and connection pipe wall is more violent,the wear is also more serious.
What problem does this paper attempt to address?