Abstract:Graphite dust is an important issue for the operation and maintenance of high-temperature gas-cooled reactor (HTGR), because the transport of fission product (FP) is coupled closely with graphite dusts. For instance, vapor phase FP could condense as flowing through the steam generator (SG) and deposit on the surface of graphite dusts that are either air-borne or already deposited on SG tubes. In water ingress or loss-of-coolant accidents, these dusts may re-suspend and contribute to the source term. Despite the importance of graphite dusts in HTGRs, the transport and deposition of dust particle are far from being fully understood, neither particle-fluid nor particle-wall interactions. In this work we present a numerical study on the particle transport through upper 5 layers of SG tubes. Particularly, the particle impaction process is simulated by Finite Element Method (FEM) with adhesion and dissipation specially accounted. The FEM simulation predicts the critical adhesion velocity and restitution coefficient when rebound occurs. Then we substitute the particle impaction model into Eulerian-Lagrangian simulation of flow field and extract the deposition rate statistically. The result shows that for small particles (< 5 μm), the deposition rate is controlled by the collision rate, which is mainly determined by the interaction between turbulence and thermophoresis. The particle-vortex interaction is essentially important for the distribution of particles near wall and thus influences the deposition rate. For large particles the deposition rate is more affected by the sticking efficiency, which is simultaneously controlled by both the critical adhesion velocity and normal impaction velocity. Therefore, the deposition rate first increases then decreases with particle size and reaches maximum at about 5 μm.

Effect of Feeding Velocity on Wear Behavior of Graphite Ball under Elevating Process with HTGR Fuel Handling System

Investigation on wear behavior of graphite ball under different pneumatic conveying environments

Wear Behavior of Graphite IG-11 in Different Gas Environments

Wear of Graphite Pebbles Modeled Using a Macroscopic Particle Model in a Pneumatic Transport Lifting Pipe

The Wear Properties of Nuclear Grade Graphite IG-11 under Different Loads

Analysis of Graphite Particle Size Under Mechanical Wear in High Temperature Gas-cooled Reactor

Nuclear Graphite Wear Properties and Estimation of Graphite Dust Production in Htr-10

A Numerical Study of Graphite Particle Motion on a Helium Turbine Wall in a High-Temperature Gas-Cooled Reactor System

ICONE23-1782 THE DESIGN OF TEST PLATFORM FOR STUDY ON ABRASION OF GRAPHITESPHERES IN THE FUEL HANDLING SYSTEM OF PEBBLE-BED HIGHTEMPERATURE GAS-COOLED REACTORS

Wear Behavior of Graphitic Matrix of Fuel Elements Used in Pebble-Bed High-Temperature Gas-Cooled Reactors Against Steel

Effect of Particle-wall Interaction on Graphite Dust Deposition on HTGR Steam Generator Tube

Friction and wear properties of matrix graphite in spherical fuel element for HTR

Graphite Dust Deposition on HTGR Steam Generator: Effects of Particle-Wall and Particle-Vortex Interactions

Theoretical Analysis on the Tribological Properties of HTGR-10 Graphite

Experimental study of thermophoretic deposition of HTGR graphite particles in a straight pipe

Temperature Effect on Ig-11 Graphite Wear Performance

Study on Graphite Particle Motion and Impact in the Helium Circulator of HTGR

A Parametric Study of Graphite Dust Deposition on High-Temperature Gas-Cooled Reactor (HTGR) Steam Generator Tube Bundles

Graphite Dust Motion in Steam Generator of High Temperature Gas-cooled Reactor

Coagulating Evolution of Graphite Dust in Helium Flow of 10 MW High-Temperature Gas-Cooled Reactor

Study of the Deposition of Graphite Dust in the Inlet Passageway of Intermediate Heat Exchanger in VHTR