Abstract:Conventional current transformers (CTs) suffer from nonlinearities due to their ferromagnetic cores. On one hand, it is well-known that severe core saturation may occur because of large overcurrents or unidirectional transient components: this may substantially impact the operation of relays. On the other hand, weaker nonlinear effects are also present during regular working conditions. In particular, the spectral content of typical current waveforms is characterized by a strong fundamental term responsible for harmonic distortion affecting the frequency components at the secondary side. In turn, this has a significant impact on the accuracy that can be reached as long as current harmonics must be monitored. The target of this work is implementing a simple signal processing technique that allows compensating for this effect. The method, characterized by extremely low computational complexity, is first introduced and validated using numerical simulations. After this, it was tested experimentally to improve the harmonic measurement capability of inductive CTs. The achieved results highlight a noticeable reduction of errors at low-order harmonics over a wide range of primary current amplitudes. It is worth noting that the black-box approach makes the technique suitable also for compensating nonlinearities introduced by current transducers based on different operating principles. Thanks to this peculiarity and to the low computational complexity, the proposed method is suitable to be employed in power quality analyzers and merging units. In this way, high-accuracy monitoring of current harmonics in power systems can be achieved, opening the way to advanced power quality management and to the location of disturbing users.

The New Type On-Line Calibrator for the Current Transformer

New method for on-line modelling of electric loads

Interferometric Fiber-Optic Current Sensor

Calibrator for electronic current transformer

A New Capacitance-to-Frequency Converter for On-Chip Capacitance Measurement and Calibration in CMOS Technology

Research of the Coupling Transformer in the New Bridge-Type Solid State Fault Current Limiter System

A Novel Method for Current Transformer Saturation Countermeasure Based on Comparing Two Currents' Polarities

Active on-site calibration technology of current transformer based on non-rated frequency current injection

An Assistant Criterion for Distinguishing Current Transformer Saturation Based on the Load Current Detection

Introduction of an intriguing approach for eletric current transformer on-site examining repairing

Study Of The Three-Phase Saturated Transformer Coupling New Bridge-Type Ssfcl

Research on the Practicality of Current Transformer Saturation Detection Using the Magnetic Restraint Principle

A Voltage Vector Residual Estimation Method Based on Current Path Tracking for T-Type Inverter Open-Circuit Fault Diagnosis

A high accuracy current comparator with electronic compensation

Online Measurement Method and System of Excitation Impedance of Current Transformers Based on Norton's Theorem and Differential Method to Measure Difference of Two Currents

A Novel Current Transformer Based on Virtual Air Gap and Its Basic Measuring Characteristics

Online Measurement Method and System of Excitation Impedance of Current Transformers Based on Norton’s Theorem and Differential Method to Measure Difference of Two Currents

VIRTUAL INSTRUMENT TECHNOLOGY IN ELECTRONIC CURRENT TRANSFORMER

Optimization Design Study of a Full-Range Charged Calibration Device for a Low-Voltage Current Transformer

A Simple Method for Compensating Harmonic Distortion in Current Transformers: Experimental Validation

A Novel Insulation Monitoring Technique for Converter Transformers Using Common-Mode Characteristic Harmonics of VSCs