Abstract:Crystallization of poly(butylene terephthalate) (PBT) thin films from the glassy state has been investigated. The thin films on the silicon substrate with a thickness of no more than 300 nm were prepared by spin-casting and were examined by grazing-incidence X-ray scattering and atomic force microscopy before and after isothermal annealing at various temperatures (T(a)s). It is found that the virgin spin-cast thin films are anisotropic amorphous, with the PBT chains preferentially lying down on the substrate. The phase structure and morphology of the annealed thin films are strongly T-a-dependent. At T(a)s below 80 degrees C, the thin films remain amorphous due to the restricted chain segment mobility imposed by the one-dimensional (1D) confinement of the thin film. For T-a of 80-180 degrees C, isothermal annealing results in dominantly smectic nodules with a size of around 10 nm, which can be sustained regardless of extending the annealing time. When T-a is in the range of 180-200 degrees C, lath-like PBT crystals of alpha-form, which are edge-on lamellae, are observed to coexist with the smectic nodules. Further increasing T-a allows the lath-like crystals to grow substantially. However, owing to the high nucleation density, the crystals are small, showing a lateral size of just several dozens of nanometers. It is interesting to note that the 1D confinement condition could largely arrest the transformation from smectic-to-crystal over a wide temperature range, letting the smectic nodules survive at T-a below 200 degrees C. We further explored the interplay of smectic and crystal phases. It is unveiled that when the well-formed nodules are taken as the initial state for crystallization, the nodules can rapidly turn into nearly square-shaped crystal particles above 200 degrees C, which serve as the element blocks for the subsequent crystal growth. The combination of these blocks makes the lath-like crystals extend their lengths. Accordingly, we conjecture that when the PBT thin films are crystallized from the glassy state, there may exist a pathway of "glass-to-smectic-to-crystal".

Extended-chain lamellar packing of poly(3-butylthiophene) in single crystals

Study on single crystals of butyl branched polyethylene in the presence of electric field

Microphase Separation And Crystallization In All-Conjugated Poly(3-Alkylthiophene) Diblock Copolymers

Concentration Effect on the Solution-state Aggregation and Thin Film Crystalline Structures of Poly(3-butylthiophene)

Crystallization assisted self-assembly of semicrystalline block copolymers

Scrolled/Cylindrical Solution-Grown Single Crystals in Form III of Isotactic Poly(1-butene)

Extended‐chain Crystals in High‐pressure Crystallized Poly(ethylene Terephthalate)/bisphenol a Polycarbonate Blends

Extended-chain lamellar crystals of monodisperse polyfluorenes

Influence of Side‐chain Isomerization on the Isothermal Crystallization Kinetics of Poly(3‐alkylthiophenes)

Oriented Crystallization of Crosslinked Cis-1, 4- Polybutadiene

Chain Conformation and Liquid-Crystalline Structures of a Poly(thieno)thiophene

Thin-Film Crystallization of Poly(butylene Terephthalate) from the Anisotropic Amorphous State

Preparation of Poly(3-Butylthiophene) Form Ii Crystal by Low-Temperature Aging and A Proposal for Form Ii-To-Form I Transition Mechanism

Constructing Thin Polythiophene Film Composed of Aligned Lamellae Via Controlled Solvent Vapor Treatment.

Sheetlike Side-Chain Liquid Crystalline Polyacetylenes Forming Monolayer Lamellae In Dilute Solutions

H-Aggregated Form Ii Spherulite of Poly(3-Butylthiophene) Grown from Solution

Morphology And Crystalline Transition Of Poly (3-Butylthiophene) Associated With Its Polymorphic Modifications

Study on the Single Crystals of Poly(3-Octylthiophene) Induced by Solvent-Vapor Annealing.

Tailoring Cocrystallization and Microphase Separation in Rod–Rod Block Copolymers for Field-Effect Transistors

Chain Trajectory, Chain Packing, and Molecular Dynamics of Semicrystalline Polymers As Studied by Solid-State NMR

SEM Observation of Large Polymer Extended-Chain Crystals in High-Pressure Crystallized PET/PC Blends