Abstract:Aluminium is one of the basic materials used in many sectors, especially in automotive, defence and aviation. Generally, aluminium parts are manufactured by using injection molding methods in many sectors, such as automotive, etc. Injection presses that are used for die-casting material have a lot of parameters, affect the molded parts’ properties. In this study, the effect of injection parameters on the mechanical properties was investigated. Firstly, a test part that is shaped currently on the injection press machine in a sector was found out. An aluminum alloy, named Al〖Si〗_12 Cu (EN AC 47000), that is used widely in die-casting techniques was preferred. Three injection parameters, such as, injection velocity (m/s), time of the mold opening (s) and molten metal temperature (0C), were selected. And all works were planned with the full factorial experimental design method. Thus, the test parts were manufactured by using an injection molding machine. Moreover, many tests, such as hardness and tensile, were performed on the test parts to investigate the effect of injection parameters on the mechanical properties of the material. The tests were analysed with the full factorial and ANOVA method. As a results of the analysis, the highest hardness value was obtained as 85 HB when the molten metal temperature was 750 °C, the injection velocity was 1.3 m/s, the mold opening time was 10 s, and the highest breaking strength was obtained as molten metal temperature 725 °C, injection velocity 4 m/s, when the mold opening time was 12 s was found to be 264 MPa.

Vacuum Die Casting Technology of Aluminum Alloy Automotive Steering Gear Housing

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Die Structure Optimization of Aluminum Alloy Wheel Low-Pressure Die Casting Based on CAE

Research Die Casting Magnesium Alloy Steering Wheel Skeleton

Die Casting Die Design and Process Optimization of Aluminum Alloy Gearbox Shell

Simulation on Die Casting Process for Magnesium Alloy Steering Wheel Frame

Study on vacuum die casting process of aluminum alloys

Determination of casting parameters of thick wall die-casting of magnesium alloy and simulation of its processing

Visualization of Die Casting Magnesium Alloy Steering Bracket

Effect of Cooling Process on Porosity in the Aluminum Alloy Automotive Wheel During Low-Pressure Die Casting

Increasing Performances in High Pressure Casting Process of Aluminium Alloys

High Pressure Die Casting Process of Magnesium Alloys and Its Modeling and Simulation for Automobile Industry

Influences of Die Casting Parameters on the Porosity in Aluminum Alloy Air-conditioning Compressor Cylinder

The Effect of Aluminium Injection Parameters on the Mechanical Properties of the Material Produced by High Pressure Die-Casting

Foundry Technology of Aluminium Alloy Cylinder Body and Cover of Car's Engine

Numerical Simulation of the Pressure Casting Process for Magnesium Alloy Steering Wheel

Material selection and process discussion of vacuum casting in automotive air intake manifold

Effects of Vacuum Die Casting Processing Parameters on Mechanical Properties of AM50 Magnesium Alloy

Research of Die-Casting Process of ZA85 Magnesium Alloys

Casting Process Design of Automobile Clutch Gear Die Castings

Influence of Processing Parameters on Microstructure and Mechanical Properties of Die Casting AM50 Alloy