Abstract:A power monitoring and protection system based on an embedded processor was designed for the junction boxes (JBs) of an experimental seafloor observatory network in China. The system exhibits high reliability, fast response, and high real-time performance. A two-step power management method which uses metal-oxide-semiconductor field-effect transistors (MOSFETs) and a mechanical contactor in series was adopted to generate a reliable power switch, to limit surge currents and to facilitate automatic protection. Grounding fault diagnosis and environmental monitoring were conducted by designing a grounding fault detection circuit and by using selected sensors, respectively. The data collected from the JBs must be time-stamped for analysis and for correlation with other events and data. A highly precise system time, which is necessary for synchronizing the times within and across nodes, was generated through the IEEE 1588 (precision clock synchronization protocol for networked measurement and control systems) time synchronization method. In this method, time packets were exchanged between the grandmaster clock at the shore station and the slave clock module of the system. All the sections were verified individually in the laboratory prior to a sea trial. Finally, a subsystem for power monitoring and protection was integrated into the complete node system, installed in a frame, and deployed in the South China Sea. Results of the laboratory and sea trial experiments demonstrated that the developed system was effective, stable, reliable, and suitable for continuous deep-sea operation.

A Distributed Synchronous Measuring System Based on GPS Synchronous Clock-carrier Power Source

Real-time power angle measurement of a synchronous generator based on gps clock signal and tachometer

WIDE AREA MEASUREMENT AND REAL-TIME TRANSMISSION SYSTEM FOR PHASOR DATA UNDER NETWORK COMMUNICATION MODE

A Timing Scheme for Power System Based on Multi-Timing Source and Multi-Mode of Timing

A New Synchronized Phasor Measurement Unit on Electric Power System

A new method of real time and synchronous measurement on power network phase parameters

Investigation of global synchronized monitoring system in power systems

Distributed Multi-Satellite Measurement Scheme Oriented Towards Microsatellite Formations

A High Accuracy Time Keeping Scheme Based on GPS

Developing a Power Monitoring and Protection System for the Junction Boxes of an Experimental Seafloor Observatory Network.

Real time data transmission in power synchronization monitoring systems

Research and Development of Comprehensive Monitoring and Management Platform for Substation

STUDY ON DISTRIBUTED PMU FOR SYNCHRONOUS PHASOR MEASUREMENT USING MUTUALLY BACKUP SYNCHRONIZATION SIGNALS FROM BOTH BEIDOU SATELLITE NAVIGATION SYSTEM AND GLOBAL POSITIONING SYSTEM

Integrated Method for Measuring Distance and Time Difference Between Small Satellites

Remote Data Acquisition System Based on SMS

IEEE 1588 Based Time Synchronization System for a Seafloor Observatory Network

Development of power system dynamic monitoring unit based on GPS

Dynamic Monitoring and Control System Based on Synchronized Phasor Measurement in Heilongjian Eastern Power System

Framework of Synchronous Dynamic Security Monitoring System Based on PMU

A Full-view Synchronized Measurement System for the Renewables, Controls, Loads, and Waveforms of Power-electronics-enabled Power Distribution Grids

Cascading Sensor Network Clock Synchronization Scheme