Abstract:The liquid state thermophysical properties and amorphous solidification kinetics of Fe50−xCoxCr14Mo14C9B8Tm5 ( x=10 , 15, 20, and 25) alloys were explored by electromagnetic and electrostatic levitation techniques. It was found that the surface tension of liquid alloys with Fe contents below 30 at. % had a strong temperature dependence. The high surface tension led to a sharp increase in the interfacial free-energy penalty. A high nucleation barrier was formed inside the melt, which greatly inhibited the nucleation rate. The liquid viscosity revealed the strong liquid feature of this alloy series, which became the dominant kinetic factor determining their solidification mechanisms. The high viscosity hindered atomic diffusion and delayed nucleation. The long crystallizing incubation time of Fe30Co20Cr14Mo14C9B8Tm5 ensured a strong glass-forming ability and a low critical cooling rate of 2.11×103Ks−1 . As a result, a bulk metallic glass rod with an 8-mm diameter was successfully prepared by a convenient casting procedure. This rod could remain in a glassy state at a higher temperature and over a wider temperature range due to its high glass-transition temperature and large undercooled liquid region. The apparent activation energy for nucleation was derived as 463.8 kJmol−1 according to the nonisothermal crystallization kinetics, indicating that the bulk metallic glass had to absorb a large amount of energy to overcome the potential barriers before nucleation and thus exhibited excellent thermal stability. https://doi.org/10.1103/PhysRevE.110.034612 ©2024 American Physical Society

Thermodynamics of La based La–Al–Cu–Ni–Co alloys studied by temperature modulated DSC

Effect of Ti addition on supercooled liquid region and glass forming ability of bulk amorphous Zr60Cu20Ni10-xAl10Tix alloys

Effect of Minor Addition of Co on Nonequilibrium Solidification of Deeply Undercooled Cu Based Alloys

Thermal Analysis by Means of Differential Scanning Calorimetry of the Characteristic Thermodynamic Temperatures of a Cu-Zr-Al Bulk Metallic Glass

IDENTIFYING THE GLASS TRANSITIONS IN Al85Ni5Y6-Fe2Co2 METALLIC GLASS USING TEMPERATURE MODU-LATED DIFFERENTIAL SCANNING CALORIMETRY

Molecular Dynamics Studies on the Correlation of Undercoolability and Thermophysical Properties of Liquid Ni–Al Alloys

Study of the Pressure−Time−Temperature Transformation of Amorphous La6Ni5Al89 by the Energy Dispersive Method for Phase Transition

Crystallization behaviour and thermal stability of two aluminium-based metallic glass powder materials

Exploring the Thermomagnetic Behavior of Co2TiZ (Z=Al, Si, Ga, Ge, and Sn) Alloys: A Computational Study

Specific Heat Determination and Simulation of Metastable Ternary Ni80Cu10Si10 Alloy Melt

Effect of Co Addition on the Glass-Forming Ability and Mechanical Properties of Ti-Zr-Be-Cu-Co Bulk Amorphous Alloys

Liquid state properties and amorphous solidification kinetics of multicomponent Fe_{50-x}Co_{x}Cr_{14}Mo_{14}C_{9}B_{8}Tm_{5} alloys investigated under containerless processing conditions

Non-Isothermal Crystallization Kinetics and Mechanical Properties of Al86ni6y4.5co2la1.5 Metallic Glass Powder

Composition- and Temperature-Dependent Liquid Structures in Al–Cu Alloys: Anab Initiomolecular Dynamics and X-Ray Diffraction Study

Crystallization behaviors of ZrCuNiAlTi4 bulk amorphous alloy during continuous heating

Thermophysical Properties of Undercooled Alloys: an Overview of the Molecular Simulation Approaches.

Thermo-mechanical properties of Cr–Co–Ni alloys from longitudinal spin fluctuation theory

Molecular Dynamics Simulation of Thermophysical Properties of Undercooled Liquid Cobalt

Liquid state properties and amorphous solidification kinetics of multicomponent alloys investigated under containerless processing conditions

Thermal stability and primary phase of Al–Ni(Cu)–La amorphous alloys

Solidification Curves of AlCu, AlMg and AlCuMg Alloys