Abstract:For multicomponent Al-based alloys, one of the most valuable approaches of microstructural design is to find a path to maximize the multiple microalloying effects while overcoming their negative counterparts. In this paper, triple Sc-Fe-Si microalloying was performed in an Al-Cu alloy to assemble the co-existence of theta'-Al2Cu and Al3Sc precipitates. Besides, the mutual interactions among triple microalloying elements were utilized to maximize the positive effects on tailoring the dual precipitates, as illustrated in two goals of microstructural design: (i). As to theta'-Al2Cu plates, the multiple Sc-Fe-Si segregation at theta'-Al2Cu/matrix interface was preferentially created in the alloy before creep (as-aged condition). During subsequent high-temperature creep, such interfacial warden will be rapidly reinforced by solute repositioning, as a process of accumulating solutes diffusing from both inner theta'-Al2Cu precipitate and outer matrix to limit the interfacial migration. (ii). For Al3Sc precipitates, the beneficial Si microalloying effect on encouraging the nucleation of Sc-rich entities (precursor of Al3Sc) was successfully acquired during aging, while the detrimental Si effect on accelerating Al3Sc coarsening is generally prohibited by tuning Fe-Si synergy within Al3Sc interior. The establishments of (i) and (ii) enable the satisfactory dispersion as well as the outstanding thermal stability of dual precipitates in the current Al-Cu-Sc-Fe-Si system, leading to a good creep resistance at a high homologous temperature of 0.61T(m) - 300 degrees C (where T-m is the melting temperature of the alpha-Al matrix).

Alloying in a System with Positive Heat of Mixing: MD Simulations of Ag-Cu

Intermixing of A System with Positive Heat of Mixing at High Strain Rates

Solid-State Alloying in Binary Systems with a Positive Heat of Mixing

Solid-state alloying in nanostructured binary systems with positive heat of mixing

Enhanced Solubility on Surfaces: Molecular-Dynamics Simulations of an Ag Overlayer on Cu(100)

The competing crystalline and amorphous solid solutions in the Ag–Cu system

Mechanical Alloying of Immiscible Elements: Ag-Fe Contrasted with Cu-Fe

Mechanical alloying in the Fe–Cu system

Molecular Dynamics Simulation Studies of Atomic-Level Structures in Rapidly Quenched Ag-Cu Nonequilibrium Alloys

Interface-Driven Solid-State Alloying in an Immiscible Cu-W System

Overlapping Solid Solubility In Mechanically Alloyed Fe-Ni And Fe-Cu

Alloying mechanisms of binary immiscible systems based on tungsten-copper composite materials

Mechanism of Ag and Al on improving the glass forming ability of CuZr-based alloys

Solid-Solution Incipient Melting of Homogenized Al–Cu–Mg–Fe Alloy

Depressing Liquid Phase Separation and Macrosegeregation of Fe–Sn Immiscible Alloys by Cu Alloying

Molecular Dynamics Simulation of Solution Strengthening of Si and Cu Atoms in Aluminum Alloy

Mechanical Alloying of the Immiscible Cu-60wt%Cr Alloy: Phase Transitions, Microstructure, and Thermodynamic Characteristics

Construction of an n-Body Potential for Revealing the Atomic Mechanism for Direct Alloying of Immiscible Tungsten and Copper

Composition- and Temperature-Dependent Liquid Structures in Al–Cu Alloys: Anab Initiomolecular Dynamics and X-Ray Diffraction Study

Solute Repositioning to Tune the Multiple Microalloying Effects in an Al–Cu Alloy with Minor Sc, Fe and Si Addition

Research on homogeneous nucleation and microstructure evolution of aluminium alloy melt