Abstract:Abstract In this paper, we propose a thermal wind speed sensor Verilog-A model with thermal-fluid-electric hybrid characteristics. Because the structure of the thermal wind sensor and the interface circuit chip are designed separately, which cannot effectively carry out MEMS-IC (integrated circuit) co-simulation, the overall performance of the sensor and interface circuit chip is prone to large deviation. At the same time, the separation of MEMS structure and IC design process leads to long product development cycle and high cost. This paper proposes an improved simulation model by analyzing the behavior characteristics of the thermal wind speed sensor. The simulation model consists of 11 thermistors, 3 capacitors, a voltage-controlled voltage source, and a voltage-controlled current source. The Taylor series expansion of the differential equation of heat conduction is carried out, and then the thermistor and capacitor networks are established according to the corresponding relationship between the thermal parameters and the electrical parameters, including the thermal conduction unit, the convection unit and the heat capacity in the chip. The model fully considers the effects of various physical effects and parasitic effects, and is implemented using the hardware description language Verilog-A. The sensor and interface circuit can be simulated simultaneously to optimize the circuit design. It is beneficial to the integration of sensors and interface circuit, reducing the number of tape-outs, increasing the success rate, and reducing costs. The consistency between the simulation results and the experimental curves verified the correctness of the macro model. The behavior characteristics of constant power (CP) and constant temperature heating were described. In CP mode, the output voltage error is less than ± 6.5%, the chip temperature error is less than 4.0%. The presented modeling approach can be the basis for the development of complete MEMS-IC design technology library of thermal wind speed sensor, aiming at optimum designs of integrated thermal wind speed sensor.

A Capacitive Membrane Mems Microwave Power Sensor in the X-Band Based on Gaas Mmic Technology

A Thermoelectric MEMS Microwave Power Sensor with Inline Self-Detection Function

A New Meshing Criterion for the Equivalent Thermal Analysis of GaAs PHEMT MMICs.

A 68.5~90 GHz High-Gain Power Amplifier with Capacitive Stability Enhancement Technique in 0.13 Μm SiGe BiCMOS

Research on a Ka-Band MEMS Power Sensor Investigated with an MEMS Cantilever Beam

X-Band High-Efficiency Continuous Class B Power Amplifier Gan Mmic Assisted By Input Second-Harmonic Tuning

Nondestructive Measurement and High-Precision Evaluation of the Electrical Conductivity of Doped GaAs Wafers Using Microwaves.

A MEMS Ultra-Wideband (UWB) Power Sensor with a Fe-Co-B Core Planar Inductor and a Vibrating Diaphragm Capacitor

J0310203 Development of Non-Contact Measurement of the Electrical Properties of GaAs Wafers

Microwave Sensor Loaded With Complementary Curved Ring Resonator for Material Permittivity Detection

Design and fabrication of X-band capacitive MEMS switches

Fabrication of Capacitive Micromachined Ultrasonic Transducer (CMUT) with PMMA/Graphene Membrane

Wafer-Level Self-Packaging Design and Fabrication of MEMS Capacitive Pressure Sensors

A Bidirectional CMOS MEMS Thermal Wall Shear Stress Sensor with Improved Sensitivity and Low Power Consumption

An Analytical Model for High Performance Capacitive RF MEMS Switch Design

A DGS-CPW Microwave Sensor Loaded With SRR for Solid Material Measurement

A Sensitivity-Enhanced Vertical-Resonant MEMS Electric Field Sensor Based on TGV Technology

An X-Band 40 W Power Amplifier GaN MMIC Design by Using Equivalent Output Impedance Model

Fabrication of a Micromachined Capacitive Switch Using the CMOS-MEMS Technology

Mmic Class-F Power Amplifiers Using Field-Plated Ganhemts

An efficient macro model for CMOS-MEMS thermal wind speed sensor