Abstract:Combining both low-temperature activity and sintering resistance to meet practical requirements is still a great challenge for the most of effective catalysts. Herein, nano ceria with different morphologies (nanosphere, nanorod, nanocube) were applied to construct novel MnOx/CeO2 catalysts by post impregnation method for catalytic combustion of carcinogenic benzene. Detail structural/physio-chemical characterizations and activity measurements were conducted to investigate the structure-dependent behavior and interfacial effect on catalytic performance and sintering resistance properties. Compared to blank ceria supports, the low-temperature activities of all MnOx/CeO2 catalysts are significantly improved, and the T90 of best-performed MnOx/CeO2 nanorods composite is only 225 °C which is 197 °C lower than that of pure ceria nanorods. Experimental studies indicate low-temperature reducibility, oxygen mobility and surface defects could be greatly promoted by introducing hetero-interface with synergistic effects between ceria and MnOx nanocrystals. Moreover, the morphology-effect on sintering resistance is dramatically different, and the T90 of spherical MnOx/CeO2 increased to only 270 °C from 245 °C after thermal ageing at 750 °C for 100 h while this value raised to 507 °C from 256 °C on MnOx/CeO2 nanocube catalyst. This exceptional sintering resistance over spherical MnOx/CeO2 can be attributed to confinement effect of Ceria nanosphere where the supported MnOx nanoparticles is trapped in the nanopores so that it’s difficult for MnOx particles to aggregate through thermal ageing treatment. In addition, due to the small contact area between the spherical particles, there is no obvious sintering phenomenon such as growth, aggregation and collapse of the spherical particles after thermal ageing, further leading to enhancement of sintering resistance. This work provides a versatile strategy for designing highly active thermal combustion catalysts with good low-temperature activities and sintering resistance for industrial applications.

A preparation process of ceria based monolithic catalysts for automobile exhaust

Nickel Nanoparticles Embedded in Porous Carbon-Coated Honeycomb Ceramics: A Potential Monolithic Catalyst for Continuous Hydrogenation Reaction

Hydrothermal synthesis and automotive exhaust catalytic performance of CeO2 nanotube arrays

Fabrication of a novel catalyst reactor with improved strength and catalytic performance used for automotive exhaust treatment

Catalytic Combustion of VOCs on Pt/CuMnCe and Pt/CeY Honeycomb Monolithic Catalysts

In-situ Synthesis of Monolithic Cu-Mn-Ce/cordierite Catalysts Towards VOCs Combustion

Facile and Flexible Preparation of Highly Active CuCe Monolithic Catalysts for VOCs Combustion

In-situ Formed Stable Pt Nanoclusters on Ceria-Zirconia Solid Solutions Induced by Hydrothermal Aging for Efficient Low-Temperature CO Oxidation

Soot Combustion Performance and H2-TPR Study on Ceria-Based Mixed Oxides

Confinement effect and Hetero-interface enable High-Performing MnOx/CeO2 oxidation catalysts with exceptional sintering resistance:Morphology effect of ceria support

Influence of Ceria-Zirconia Solid Solution on Performance of Noble Metal Monolithic Oxidation Catalyst

Effect of synthesis method on the properties of ceria–zirconia modified alumina and the catalytic performance of its supported Pd-only three-way catalyst

Effect of Preparation Methods on the Structure and Redox Behavior of Platinum–ceria–zirconia Catalysts

Ceria engineering in nickel catalysts to improve CH 4 selectivity and yield for CO methanation

Cordierite Honeycomb Ceramics Used for Purification of Vehicle Exhaust

Preparation and Properties of Ceria Supported Palladium Catalyst

Mass Transfer Enhancement and Drying Mechanism of High Adhesion Saturated Impregnated Co-Al2O3 Monolithic Catalyst

Application Of Rare Earth Modified Zr-Based Ceria-Zirconia Solid Solution In Three-Way Catalyst For Automotive Emission Control

On preparation of noble metal-rare earth compounds and their performance as a complex catalyst

Effects of the Addition of Small Quantities of Ceria on the Catalytic Behavior of Pd-Only Close-Coupled Catalysts During Automobile Exhaust Elimination

Honeycomb monolithic design to enhance the performance of Ni-based catalysts for dry reforming of methane