Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

A Current-Limiting Protection Strategy for the Combined Three-Phase Inverter

A Control Strategy for Power-network-incorporated Inverter Based on TMS320LF2407

A Short-Circuit Fault-Tolerant Strategy for Three-Phase Four-Wire Flying Capacitor Three-Level Inverters

A Current-Sharing Method Based on Networked Control for Three-Phase Parallel Inverter

Implementation of Inverter Incorporated in Power Network Based on Voltage Phasor Diagram

A Novel Current-Limit Strategy Used in High Power Step-Down Converter

A Novel Current Control Strategy for Three-Phase Gird-Connected Inverters

STUDY ON THREE-PHASE MAIN CIRCUIT TOPOLOGY AND CONTROL STRATEGY FOR A NEW-TYPE SOLID-STATE CURRENT LIMITER

Protection and Fault Isolation Scheme for DC Distribution Network Based on Active Current-Limiting Control

Start-stop Control Strategy for UPFC with Fault Current Limiting

Simulation Study of Series Resonance Type Fault Current Limiter

Control Strategy and Test Study of Bi-directional Current's Solid State Fault Current Limiter

A Novel DC Current Injection Suppression Method for Three-Phase Grid-Connected Inverter Without the Isolation Transformer

Modulation and Control of a New Alternate Arm Multilevel Converter for High-Voltage Direct Current System with Direct Current Fault Ride-Through Capability

A DC Solid-State Current Limiter With Adaptive Current-Limiting Ability

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

A Hybrid Current-Limiting Circuit for DC Line Fault in Multiterminal VSC-HVDC System.

Combined Current Sensing Method for the Three-Phase Quasi-Z-Source Inverter

An Integrated Control and Protection Scheme Based on FBSM-MMC Active Current Limiting Strategy for DC Distribution Network

Safe Stop-Pulsing Strategy for IGCT-based Three-Level Neutral Point Clamped Inverters

Research on Inverter Over-current-limiting Methods