Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

GLS/GGLS/SUPG Method in 3D Numerical Simulation of Filling Stage of Plastic Injection Molding

Numerical simulation of filling flow of polymer melt in injection molding

3D Simulation of Filling Stage of Plastic Injection Molding Based on Improved Finite Volume Method

Inflow and Outflow Numerical Simulation Using Least-Square Moving Particle Semi-Implicit Method on GPU

A Gradually Implicit Method with Deferred Correction and Adaptive Relaxation Factors for Simulation to Nonlinear Heat Transfer.

Examination of Appropriate Formulations for Velocity and Pressure Calculation Methods at Interfacial Region on Collocated Physical Variables' Distribution

3D Flow Simulation for Viscous Nonisothermal Incompressible Fluid in Injection Molding

Simplex space-time meshes in thermally coupled two-phase flow simulations of mold filling

Appropriate Formulations for Velocity and Pressure Calculations at Gas-liquid Interface with Collocated Variable Arrangement

NUMERICAL METHOD OF PACKING ANALYSIS IN INJECTION MOLDING OF POLYMERS

A Generalized Coupled Level Set/volume-of-fluid/ghost Fluid Method for Detailed Simulation of Gas-Liquid Flows.

Formulations and Validations of a High-Precision Volume-of-Fluid Algorithm on Nonorthogonal Meshes for Numerical Simulations of Gas Entrainment Phenomena

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio

Development of SPH for simulation of non-isothermal viscoelastic free surface flows with application to injection molding

Numerical Study of Heat Transfer and Temperature in the Screw Groove for Molten Plastic

Numerical simulation of mold filling of casting with an improved SOLA-VOF method

SIMULATING PRESSURE DISTRIBUTION ON LENS RELEVANT TO FLUID INJECTION FOR IMMERSION LITHOGRAPHY

3D Simulation of Residual Thermal Stress and Shrinkage in Plastic Injection Molding

Accuracy and Stability Enhancements in the Incompressible Finite-Volume-particle Method for Multiphase Flow Simulations.

A Multiscale Simulation of Polymer Melt Injection Molding Filling Flow Using SPH Method with Slip-Link Model

Variational multi-scale finite element method for the two-phase flow of polymer melt filling process