Abstract:Tn the medium voltage range the vacuum switching principle is well established (Fink and Renz, 2002). Today vacuum circuit breakers are available up to 52 kV rated voltage and 80 kA short-circuit current. By using a series arrangement of two or more vacuum interrupters it is basically possible to double or multiply the dielectric strength without increasing the operating energy substantially. Applications with two 24 kV or 36 kV standard vacuum interrupters in series for rated voltages of 52kV or 72kV are well known. In principle there is no restriction on the medium voltage range for single vacuum interrupters. Tubes for 72kV and even 145kV applications are described by several manufacturers. However due to a nearly square-root dependence between the dielectric strength and the contact stroke it is not trivial to find acceptable solutions. Concerning environmentally aspects also the external insulation of the interrupter causes problems. SF6 is well established in compact gas-insulated switchgears (GTS). Of course designs for air-insulated switchgears (AIS) are possible. But adequate solutions have to be found. Another issue to be considered is the interrupting capability. The dependence on contact stroke for conventional contact systems may limit short circuit current interrupting capability. The higher the stroke the lower the maximum current, which can be proper, interrupted. Increasing of the contact diameter ad infinitum is useless. Switching capacitors is the next technical challenge. On one side a dielectric sufficient stroke is necessary, on the other side increasing contact gap reduces the interrupting capability. Overvoltages produced by switching inductances also deserve closer attentions. Common contact materials for medium voltage vacuum interrupters are maybe not suited for low surge behaviour in high voltage devices. Together with the electrical items the mechanical stability of the interrupter has not to be sneezed at. The endurance of the bellows and housing as well as the bending and upsetting of the conduction bolts demand high sophisticated engineering. In spite of all the technical problems proper solutions up to 72kV were developed in the past and 145kV-bottles with a single interrupter gap are possible. The main handicap against the introduction of vacuum technology into the high voltage domain is obviously the economical efficiency. Well established technologies and production facilities enable cost-effective products today. A decision pro vacuum is possible for high voltage applications as recently as technical and commercial solutions are available

A Gravity Heat Pipe for High Voltage Vacuum Interrupter

Heat Transfer in a High-Voltage Vacuum Circuit Breaker

Structure Improvement of a 126 Kv Vacuum Circuit Breaker Using Electromagnetic-Thermal Field Coupling Simulation

Study on the Contact Resistance and Temperature-rise Performance of High-voltage Vacuum Interrupter

Novel Heat Pipe Current-Carrying Tube of RIP Valve-Side Bushing in Converter Transformer

Numerical Study of Large Contact Diameter and Gap High Current Vacuum Arc

3D Modeling and Simulation of High-Current Vacuum Arc Subjected to Real External Transverse Magnetic Field

High Current Breaking Technology of LV Vacuum Circuit Breaker

A Fast LVDC Vacuum Hybrid Circuit Breaker: Dielectric Recovery and Design Consideration

Application of Heat Pipe Technology on Averaging Temperature of UHV Converter Valve-Side Bushing

Physics of high-current interruption of vacuum circuit breakers

Development of High-Voltage Vacuum Circuit Breakers in China

High Voltage Vacuum Interrupters; Technical and Physical Feasibility versus Economical Efficiency

Design of Opening Velocity for a Vacuum Interrupter With a Cup-type Axial Magnetic Field Contact Based on Vacuum Arc Anode Discharge Mode

Numerical Study of Large Contact Diameter and Gap Vacuum Arc in 252kV Vacuum Interrupter

Current distribution and power loss within the sliding contact structure of vacuum circuit breaker

A Low Resistance Vacuum Interrupter Electrode with Hook Support under Contact Plates

Experimental Investigation of Vacuum Arc under Different Axial Magnetic Field Contacts for 40.5 Kv Vacuum Interrupters

Electric Insulation Characteristics of Long Contact Gap in High Voltage Vacuum Interrupter

Development of 126 kV Single-break Vacuum Circuit Breaker

Influence of no-load operation and current switching on breakdown characteristics of high voltage vacuum interrupters at contact gap 30mm