Abstract:<span class="a-plus-plus abstract-section id-a-sec1"> <h3 class="a-plus-plus">Abstract</h3> <p class="a-plus-plus">This study is an experimental investigation of the effectiveness and mechanism of a concept for bluff-body control characterized by combined windward suction and leeward blowing (WSLB). Wind tunnel tests are performed at a subcritical Reynolds number (<em class="a-plus-plus">Re</em>) of 3.33 × 10<sup class="a-plus-plus">4</sup>. Open-loop WSLB is used to control the flow around a cylindrical test model. Distributed suction and blowing nozzles are symmetrically arranged at the front and rear stagnation points. Steady suction and blowing are implemented simultaneously on both surfaces of the cylinder. WSLB control is characterized by the dimensionless momentum of the suction/blowing relative to the incoming airflow. Instantaneous pressure distributions on the midspan of the cylinder surface for the baseline and controlled cases are measured to quantify the modifications of WSLB control to the aerodynamic coefficients of the cylinder. In addition to surface pressure measurements, a particle image velocimetry (PIV) system is used to describe the wake flow structures of the baseline and controlled cylinders. Experimental results demonstrate that WSLB control decreases sectional drag at the midspan and reduces the fluctuating amplitudes of dynamic wind loads acting on the cylinder. The Strouhal number to characterize the vortex shedding frequencies of the controlled cylinders is also found to deviate from that of the natural cylinder. PIV measurement results show that the active blowing positioned at the leeward stagnation point forms a pair of vortices into the cylinder wake that modify the original vortex shedding process. As the blowing vortices convect into the wake, they stretch the unsteady shear flows from the upper and lower sides of the cylinder, increase the vortex-formation length and push the alternative vortex shedding further downstream. It is also shown that a steady and symmetric perturbation imposed on the periodic cylinder flow can reduce the von Karman vortices and modify the mode of wake vortex shedding significantly.</p> </span> <span class="a-plus-plus abstract-section id-a-sec2 outputmedium-all"> <h3 class="a-plus-plus">Graphical abstract</h3> <p class="a-plus-plus">With active control of windward suction and leeward blowing (WSLB), blowing positioned at the leeward stagnation point forms a pair of vortices in the cylindrical wake that modifies the typical vortex shedding process. As the blowing vortices convect downstream, they contribute to detaching the unsteady shear layers from the cylinder. It is shown that a steady and symmetric perturbation imposed on the periodic cylinder flow can lead to a symmetric mode of wake vortex shedding. <span class="a-plus-plus figure category-standard float-no id-figa"> <span class="a-plus-plus media-object"> <img alt="" src="https://static-content.springer.com/image/MediaObjects/348_2018_2676_Figa_HTML.png" class="a-plus-plus"/> </span> </span> </p> </span>

Optimal Control of Cylinder Wakes Via Suction and Blowing

System Identification and Model Predictive Control of Vortex Shedding Behind a Rotating Cylinder

Suppression of Vortex Shedding for Flow Around A Circular Cylinder Using Optimal Control

Control of Vortex Shedding from Two Side-by-side Cylinders Using a Pair of Tangential Jets

A zero-net-mass-flux wake stabilization method for blunt bodies via global linear instability

Suppression of Oscillatory Fluid Forces in Cylinder Wake: Optimal Jet Control Position Designed Through Resolvent Analysis

Active control of circular cylinder flow with windward suction and leeward blowing

Reduced-Order Modelling and Closed-Loop Control of the Cylinder Wake

Resolvent-based approach for H2-optimal estimation and control: an application to the cylinder flow

Applying Reinforcement Learning to Mitigate Wake-Induced Lift Fluctuation of a Wall-Confined Circular Cylinder in Tandem Configuration

Wake Control of a Bluff-Body Via Distributed Jets over Its Surface

Numerical Investigation of Steady Suction Control of Flow Around a Circular Cylinder

Active Control of Vortex-Induced Vibration of a Circular Cylinder Using Machine Learning

Primary instability, sensitivity and active control of flow past two tandem circular cylinders

Active control of the flow past a circular cylinder using online dynamic mode decomposition

Rotationary Feedback Control of the Cylinder Wake Flow Using a Linear Dynamic Model

Wake Flow Control of a Square Cylinder Via Distributed Jets over the Rear Porous Surface

Wake stabilization behind a cylinder by secondary flow over the leeward surface

Transition control of cylinder wake via Lorentz force

Passive Jet Approach to Control the Flow over a Circular Cylinder

Active control of vortex-induced vibration of a circular cylinder by using the oscillatory plate immersed in the cylinder wake at low Reynolds number