Abstract:<span class="a-plus-plus abstract-section id-a-sec1"> <h3 class="a-plus-plus">Abstract</h3> <p class="a-plus-plus">This study is an experimental investigation of the effectiveness and mechanism of a concept for bluff-body control characterized by combined windward suction and leeward blowing (WSLB). Wind tunnel tests are performed at a subcritical Reynolds number (<em class="a-plus-plus">Re</em>) of 3.33 × 10<sup class="a-plus-plus">4</sup>. Open-loop WSLB is used to control the flow around a cylindrical test model. Distributed suction and blowing nozzles are symmetrically arranged at the front and rear stagnation points. Steady suction and blowing are implemented simultaneously on both surfaces of the cylinder. WSLB control is characterized by the dimensionless momentum of the suction/blowing relative to the incoming airflow. Instantaneous pressure distributions on the midspan of the cylinder surface for the baseline and controlled cases are measured to quantify the modifications of WSLB control to the aerodynamic coefficients of the cylinder. In addition to surface pressure measurements, a particle image velocimetry (PIV) system is used to describe the wake flow structures of the baseline and controlled cylinders. Experimental results demonstrate that WSLB control decreases sectional drag at the midspan and reduces the fluctuating amplitudes of dynamic wind loads acting on the cylinder. The Strouhal number to characterize the vortex shedding frequencies of the controlled cylinders is also found to deviate from that of the natural cylinder. PIV measurement results show that the active blowing positioned at the leeward stagnation point forms a pair of vortices into the cylinder wake that modify the original vortex shedding process. As the blowing vortices convect into the wake, they stretch the unsteady shear flows from the upper and lower sides of the cylinder, increase the vortex-formation length and push the alternative vortex shedding further downstream. It is also shown that a steady and symmetric perturbation imposed on the periodic cylinder flow can reduce the von Karman vortices and modify the mode of wake vortex shedding significantly.</p> </span> <span class="a-plus-plus abstract-section id-a-sec2 outputmedium-all"> <h3 class="a-plus-plus">Graphical abstract</h3> <p class="a-plus-plus">With active control of windward suction and leeward blowing (WSLB), blowing positioned at the leeward stagnation point forms a pair of vortices in the cylindrical wake that modifies the typical vortex shedding process. As the blowing vortices convect downstream, they contribute to detaching the unsteady shear layers from the cylinder. It is shown that a steady and symmetric perturbation imposed on the periodic cylinder flow can lead to a symmetric mode of wake vortex shedding. <span class="a-plus-plus figure category-standard float-no id-figa"> <span class="a-plus-plus media-object"> <img alt="" src="https://static-content.springer.com/image/MediaObjects/348_2018_2676_Figa_HTML.png" class="a-plus-plus"/> </span> </span> </p> </span>

On the distributed blowing control of flow around a square cylinder at a low Reynolds number

The Effect of Slip Distribution on Flow Past a Circular Cylinder

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Active control of circular cylinder flow with windward suction and leeward blowing

Direct Numerical Simulation of Skin Friction Drag Reduction on Supersonic Turbulent Boundary Layers with Micro-Blowing

Numerical Study on Flow Past a Confined Half Cylinder in Two Bluff Arrangements

Numerical Study on Flow Around Four Square-Arranged Cylinders at Low Reynolds Numbers

Drag Reduction of Blowing-Based Active Control in a Turbulent Boundary Layer

Active control of the flow past a circular cylinder using online dynamic mode decomposition

Numerical study on the flow control mechanisms of an off-surface circular cylinder for wall-bounded flows with separation

Control of circular cylinder flow via bilateral splitter plates

Three-dimensional Numerical Simulation on Flow Past Three Circular Cylinders in an Equilateral-Triangular Arrangement

Experimental study on the wake control of a square cylinder mounted with dual rigid/flexible splitter plates in the subcritical regime

A computational study of drag reduction and vortex shedding suppression of flow past a square cylinder in presence of small control cylinders

Simulation of Flows Around Two Tandem Rotating Cylinders in a Channel Using LB-DF/FD Method

Numerical Simulation for Flow Over two Circular Cylinders in Side-by-side Arrangement with Lattice Boltzmann Method

A zero-net-mass-flux wake stabilization method for blunt bodies via global linear instability

Wake stabilization behind a cylinder by secondary flow over the leeward surface

Effects of Localized Micro-blowing on a Spatially Developing Flat Turbulent Boundary Layer

Numerical analysis of the flow over four side-by-side square cylinders with different gaps

Low-Reynolds-number flow past a cylinder with uniform blowing or sucking