Abstract:This paper studies a dual-wavelength single-frequency Er-doped fiber laser based on ring cavity, the output wavelengths are 1 570 nm and 1 548 nm. The laser combines Fabry-Perot (FP) filter and Fiber Bragg Grating (IFBG) to achieve wavelength selection and preliminary stabilization. And two unpumped Er-doped fibers act as saturable absorbers to realize linewidth narrowing effect. The Laser Diode (L.D) used has a maximum drive current of 700 mA, which corresponds to a maximum pumping power of 450 mW and 500 mW. When the pump power of LD1 is up to 58 mW and the diver current of LD2 is up to 138 mW, the fiber laser gets dual-wavelength output. The output power of the 1 570 nm and 1 548 nm laser generated at this time are 4.2 mW and 10.1 mW respectively. Then the pump power of LD1 and LD2 are adjusted to 104 mW and 83 mW respectively, and the output laser characteristics were studied under this condition. The output power in 1 570 nm is 10.3 mW, the Optical Signal to Noise Ratio (OSNR) is 58 dB. The output power in 1 548 nm is 4.7 mW, and the OSNR is 55 dB. It shows that the output laser has a relatively high-quality factor and high slope efficiency. Then the stability of the output laser is studied. In order to measure the stability of the output laser of the dual-wavelength single-frequency laser, data collection is started half an hour after the laser is turned on in the experiment. Every 10 min, the spectrum is collected and the output power is recorded. The power fluctuations of the laser output in 1 370 run and 1 548 nor are 0.01 dBm and 0.02 dBm, respectively, and the wavelength drifts of the output laser are both less than 0.01 nm. The result shows that the fiber laser can avoid the mutual interference between the two wavelengths. The output laser has good power stability and wavelength stability. The laser linewidth is the parameter of most concern fora single-frequency fiber laser. In this experiment, the linewidths of the output laser are measured by the delay non zero self heterodyne method based on the Mach-Zehnder interferometer and fitted with the Lorentz curve. And it can be calculated from the 20 dB bandwidth of the Lorentz curve. The linewidths of output laser in 1 570 urn and 1 548 urn measured are about 230.2 Hz and 223.6 Hz. The narrow linewidth indicates that the output laser has good single frequency performance, and it is also an important basis for the wide application of this laser. In this study, the idea of multiplexing Fiber Fabry-Perot (FFP) filter is proposed, and the two sub-cavities do not interfere with each other by introducing circulator at both ends of FFP. It also does riot introduce any expensive polarization devices, and does riot need to use a polarization controller to control the polarization state of the tight in the cavity. So it greatly reduces the difficulty of experimental operation and cost of the experiment. The fiber laser has a simple structure, good stability and the output laser has a narrow linewidth. It provides a technical method for realizing dual-wavelength single frequency laser output, and it can also be used as a seed tight source in high precision measurement field.

Stable single frequency Er-doped all-fiber ring laser with fiber Bragg grating Fabry-Perot filter

Tunable and Programmable Fiber Ring Laser Based on Digital-Controlled Chirped Fiber Bragg Grating

Stable single-mode compound-ring erbium-doped fiber laser

An Injection-Locked Single-Longitudinal-Mode Fiber Ring Laser with Cylindrical Vector Beam Emission

Narrow Line-Width Ytterbium-Doped Fiber Ring Laser Based on Saturated Absorber

A Widely Tunable Single-Longitudinal-mode Ytterbium-Doped Fiber Laser Based on Fiber Lyot Filter

Tunable and Switchable Six-Wavelength Erbium-Doped Fiber Ring Laser

Tunable Erbium-Doped Fiber Ring Laser Based on an All-Fiber Filter

Short-wavelength multiline erbium-doped fiber ring laser by a broadband long-period fiber grating inscribed in a taper transition

Single-longitudinal-mode erbium-doped fiber laser based on a fiber-Bragg-grating pair

Single-frequency Q-switched erbium-doped fiber ring laser by combination of a distributed Bragg reflector laser and a Mach-Zender interferometer

1 570 nm and 1 548 nm Dual-wavelength Single-frequency Er-doped Fiber Laser

Fiber Bragg gratings fabricated by femtosecond lasers for narrow-linewidth fiber laser

A single frequency fiber laser with an on-chip high-Q silicon microring cavity

Multiwavelength Er-doped fiber laser using an all-fiber Lyot filter

Single-frequency pulsed fiber laser based on an electro-optic modulator with injection seeding technique

Fabrication of integrated single frequency DBR fiber laser directly on ytterbium doped fiber by femtosecond laser

Fabrication and performance research of high-stability Brillouin ring laser

Multiwavelength Brillouin/Erbium fiber laser with four-fold frequency shift spacing

Broadband tunable single-frequency Yb-doped fiber laser with dual ring subcavity and Sagnac ring filter

Single-frequency linear cavity erbium-doped fiber laser for fiber-optic sensing applications