Abstract:As the parameters of the photoelectric detector have important effects on the performance of the dispersive spectrometers, it is necessary to detail the discrete sampling process of the photoelectric detector array. In the present paper, the sampling model was setup, and the effects on the sampling results caused by the spatial frequency of the cosine signal, the width of the sampling pixel, and the initial phase of the sampling pixel position to the crest of the input cosine signal were discussed thoroughly in the frequency domain. By introducing the integral function, a general expression of the sampling modulation transfer function was given, and the concept and expression of the average sampling modulation transfer function was proposed. Since that expression eliminates the effect of initial phase, it is much more convenient to the practical applications. For the typical Gaussian spectrum produced by the dispersive spectrometer, the Fourier transform result of that spectrum was multiplied by the average sampling modulation transfer function to produce a functional expression of the modulation transfer function of the whole system. The average aliasing error of the sampling process was expressed as a function of spatial frequencies; the relationship between the peak value of the average aliasing error and the width of the Gaussian spectrum was discussed; and the critical value of the spectrum width to restore this spectrum precisely was proposed. That critical value is significant for providing guidance to the design and fabrication of dispersive spectrometers.

Peak fitting methods for CdZnTe detector in γ spectrometer

Analytical Fitting of Gamma-ray Photopeaks in Germanium Cross Strip Detectors

Direct Demodulation Method for Γ Spectra Analysis Detected by CZT Detectors

The Analysis of the Sampling Modulation Transfer Function and the Influence on the Gaussian Spectra

Evaluation of Peak-Fitting Software for Gamma Spectrum Analysis

Basic Characterization of CdZnTe(CdTe) Detectors

A Method for Interpolating Asymmetric Peak Shapes in Multiplet Γ-Ray Spectra

Detection of CdZnTe Detectors to Low Energy Photos

CdZnTe quasi-hemispherical detector for gamma–neutron detection

Spectrum construction methods improving gamma-ray detection efficiency for pixelated CZT detectors

Progress in the Development of CdZnTe Unipolar Detectors for Different Anode Geometries and Data Corrections

Performance Simulation and Structure Design of Binode Cdznte Gamma-Ray Detector

Recent Progress in CdTe and CdZnTe Detectors

Use of CdZnTe Quasi-Hemispherical Detectors under the Impact of Low Temperatures and High-Gamma Radiation Fluxes

Temperature Peak-Drift Correction Method for NaI(Tl) Detectors Using the Background Peak

Method for Unfolding Multiplet Regions of X- and Γ-Ray Spectra with a Detection Efficiency Constraint Avoiding Inflecting the Peak Shapes for Correction Results

The Influence of Detector Spectral Response on the Peak Position Determination in the Spectrometer Wavelength Calibration Process

Study of Thick CZT Detectors for X-ray and Gamma-Ray Astronomy

Monte Carlo simulations of the SNM spectra for CZT and NaI spectrometers

The full-energy peak efficiency of gamma-ray spectrometry by numerical calculation method

Multi-energy Detection Using CdZnTe Semiconductor Detectors