Abstract:It is predicted that the thickness of a coating has major effects on a substrate in terms of mechanical and thermal properties. In this study, an Al 2 O 3 –ZrO 2 –SiO 2 slurry was prepared as a coating material, which formed an alumina–zirconia–mullite composite coating after sintering. The alumina–zirconia–mullite composite coating was coated on a zirconia substrate to generate compressive stress in the coating due to the mismatch of the coefficient of thermal expansion (CTE). A series of coated samples with different coating thicknesses from ∼10 μm to ∼200 μm were prepared to investigate the effects of coating thickness. The residual compressive stress, thermal conductivity, CTE, and Young's modulus of the coating material were determined by relative methods, and the flexural strength of the coated and uncoated samples was measured by 3-point bending. The strength of the coated samples was 1362.98 ± 30.29 MPa, which is a 54.07% enhancement compared to the uncoated samples. The thermal conductivity of the coated samples was also increased compared to that of the uncoated samples. For a given thickness of the substrate of 2 mm, there was an optimum thickness of the coating of 90 μm, which showed the greatest strength compared to the other samples. Coatings that were too thin or too thick did not show the best reinforcement. Moreover, the porosity of the coated samples was also determined and discussed in this study. Comparison samples without SiO 2 were also manufactured, and their flexural strength and thermal conductivity were found to not be as good as the samples with SiO 2 .

Effect of ZnAl<sub>2</sub>O<sub>4</sub> coating of whisker surface on Young's modulus of Al<sub>18</sub>B<sub>4</sub>O<sub>33</sub>w/Al composite

MMCs with Controlled Non-Uniform Distribution of Submicrometre Al2O3particles in 6061 Aluminium Alloy Matrix

High strength-ductility synergy of MgAlB4 whisker reinforced aluminum matrix composites achieved by in situ synthesis

Effect of coating Al2O3 reinforcing particles on the interface and mechanical properties of 6061 alloy aluminium matrix composites

Microstructure and Mechanical Properties of ABOw and Nickel-Coated MWCNTs Reinforced 2024al Hybrid Composite Fabricated by Squeeze Casting

Fabrication and mechanical properties of α-Al2O3 whisker reinforced cu-graphite matrix composites

Effect of surface modification of Al2O3 powder with Y2O3 on microstructure and tensile properties of aluninium matrix composites

Silicon Nitride Whisker-Reinforced Aluminum Matrix Composites: Twinning and Precipitation Behavior

Influence of particulate B4C with high weight fraction on microstructure and mechanical behavior of an Al-based metal matrix composite

Effect of Interfacial Reactions on Solid Erosion of Al_(18) B_4O_(33) Whisker-Reinforced AC4C Al Alloy Matrix Composites

Microstructure and property evolution of aluminium/potassium titanate whiskers composite during Rheo-casting

Influence of alumina whisker or nano-carbon contents on the microstructure and mechanical properties of CuZrTiAlNi refractory high entropy alloy composites

Effect of Cr micro-alloying on microstructure and mechanical properties of alumina whisker and graphene co-reinforced copper matrix composites

Rare-Earth Oxide Coating for Sub-Micro Particulates Reinforced Aluminum Matrix Composites

Mechanical Properties of Silicon Carbide Whisker-Reinforced Silicon Nitride Matrix Composites

Mechanical behavior of Y 2 O 3 -coated Al 2 O 3p /6061 Al composites

Thickness effect of an alumina–zirconia–mullite composite coating on the properties of zirconia

Comparison of sintering behavior and reinforcing mechanisms between 3Y-TZP/Al2O3(w) and 12Ce-TZP/Al2O3(w) composites: Combined effects of lanthanide stabilizer and Al2O3 whisker length

Effect of interfacial reactions on solid erosion of Al18B4O33 whisker-reinforced AC4C Al alloy matrix composites

Potential Application of Aluminum Matrix Composites Reinforced by Al_2O_3 Crystal Whiskers

Toughening effect and mechanisms of AlN whiskers on a low‐temperature sintered AlNw/AlN ceramics