Abstract:With the progress in modern high-energy physics, the Standard Model is constantly being refined. As the last brick of the Standard Model, the Higgs boson was confirmed to be discovered in the Large Hadron Collider (LHC) in 2012. For the further exploration of the Higgs boson, the Circular Electron Positron Collider (CEPC) is proposed. The baseline detector concept of CEPC is guided by the particle flow principle. The Particle Flow Algorithm (PFA) reconstructs a list of low-level particles and associates every detector hit with these particles. The high granularity hadronic calorimeter (HCAL) represents an essential component of PFA-based detectors. This paper mainly presents the single-layer electronics design and development for the scintillator analog hadronic calorimeter prototype (AHCAL). The single-layer readout electronics consists of front-end electronics board (FEB) and data interface (DIF) board. The FEB carries the silicon photomultipliers (SiPM), plastic scintillators, and the SiPM signal readout circuit. A single SiPM coupled with a scintillator constitute the basic detection unit. The size of scintillator used here is 4 cm x 4 cm. A sensitive area of 72 x 72 cm(2) can be covered by the design presented here. 324 SiPMs coupled with scintillators are mounted on each FEB. Besides the huge sensitive area, The AHCAL prototype must also meet strict requirements on the integration and robustness of the electronics. This paper develops a complete single-layer readout electronics design that meets the requirements for use in the AHCAL. The results of beam test shows that the peak of the minimum ionizing particle (MIP) is separated from the pedestal evidently and the signal-to-noise ratio (SNR) is better than 20. The volume required for the electronics is less than 4 cm3 per channel. In addition, the FEB is sufficiently robust to avoid damage during intercontinental transportation. The development of the single-layer electronics represents significant progress in the design of a prototype device that meets the requirement for use in the CEPC.

Design of Readout Electronics for BESIII Crystal Calorimeter Integrated Dose Monitoring System

Design of readout electronics for BESIII online dose rate monitoring and protection system

Prototype Design of Readout Electronics for In-Beam TOF-PET of Heavy-Ion Cancer Therapy Device

Design of the Online Integral Dose Monitor System for Besiii Emc

Study of the Features of 400nm IMPL RADFET Dosimeter

Design of rf front end for cavity beam position monitor based on ics *

Calibrasion of the energy response for the soft x-ray detections elements with the beijing- synchrotron radiation facility

Online Measurement of the BEPC II Background Using RadFET Dosimeters

Development of readout electronics a novel beam monitoring system for ion research facility accelerator

Preliminary Design of a FADC Readout System for the Alpha/Beta Discrimination in a Large Area Plastic Scintillation Detector

The Single-Layer Readout Electronics Design and Development for CEPC Scintillator Analog Hadronic Calorimeter Prototype

Design of the Readout Electronics for the Qualification Model of DAMPE BGO Calorimeter

Design of a high-dynamic-range prototype readout system for VLAST calorimeter

A Radiation Detection Readout Circuit with Current Feedback Baseline Holder

Deployment of the readout electronics for the BESIII Cylindrical GEM Inner Tracker

Applications for Synchrotron Radiation in Inertial Confinement Fusion Research

An Integrated Readout Circuit for Personal Dosimetry with Phase-Shift Compensation Technique to Improve Stability.

Energy Loss Correction for A Crystal Calorimeter

The Design of Area Radiation Dose Monitoring System

Design of infrared radiation diagnostic calorimeter for the prototype radio frequency driven negative ion source for neutral beam injection

Design and Optimization of the CEPC Scintillator Hadronic Calorimeter