Abstract:Reinforced concrete link or coupling beams are usually cast integral with wall piers to help them act as a unit to resist lateral loads. The use of deep beam design in ACI 318-19 provisions leads to conservative shear designs for link beams which do not follow Euler-Bernoulli beams. Instead, strut-and-tie systems are used. The paper demonstrates the modeling of such beams using strut-and-tie provisions of ACI 318-19 Ch. 23. Alternatively, to using a time-consuming trial-and-error process, a unified general multi-panel strut-and-tie model is proposed, and simple design equations are developed to directly design conventionally reinforced link beams subjected to high shear force demand. As link beams have often a small span-to-depth ratio, the first one- and two-panel strut-and-tie models are considered basic and common. The one-panel model consists of a direct inclined compression concrete strut with horizontal tension ties in addition to the required crack-control web reinforcement and is used wherever the strut-tie angle is greater than the ACI minimum of 25 degrees; one vertical-to-two horizontal. The two-panel model is used when the beam span is too long to use the one-panel model and consists of one vertical tension tie and two steep inclined compression concrete struts. Worked design examples have been presented to justify and demonstrate the ease of implementation of the considered first two simple and direct models of the proposed unified general multi-panel strut-and-tie model. The predictions of the two basic models have been compared with five sample calculations and the comparison shows a good agreement.

Strut-and-tie Model of Deep Beam Design Subjected to Two Movable Loads

Strut-and-tie Model of Deep Beam Design Under Uniform Distributed Loads

Strut-And-Tie Model Research On Bridge Column-Pile-Footing

Application of Strut-and-tie Model in Design of Reinforced Concrete Deep Beams

A unifying strut-and-tie model for conventionally reinforced link beams

Optimal strut-and-tie model for shear analysis of RC deep beams

Strut-and-tie model of simply supported beams under different prestressing degree

Strut-and-tie Model Method for Design of Reinforced Concrete Structures:Part Ⅰ Model Development

Development of Strut-and-Tie Models Using Load Path in Structural Concrete

Elastic-to-Plastic Strut-and-Tie Model for Deep Beams

Modified Strut-and-tie Model for Prestressed Concrete Deep Beams

Strut-and-tie Models and Reinforcement Design for Prestressed Anchorage Plates

Application of Simplified Softened Strut-and-tie Model in the Design of Interior Reinforced Concrete Beam-Column Joints

Improvement and Application of the Softened Strut-and-Tie Model

Development of Strut-And-Tie Model and Design Guidelines for Improved Joint in Decked Bulb-Tee Bridge

STRUT AND TIE MODEL OF ANCHORAGE ZONE BASED ON MULTI-NODE MICRO TRUSS ELEMENT

Strut-and-tie models for end anchorage zones in prestressed concrete T-section girder bridges and reinforcement design

STRUT-AND-TIE MODEL FOR INTERMEDIATE ANCHORAGES IN POST-TENSIONED CONCRETE BRIDGES

Experimental Study on Shear Behavior of Prestressed Concrete Deep Beams with Draped Tendons

Strut-and-tie Model Method for Design of Reinforced Concrete Structures-Part Ⅱ:design

Study on Mechanical Behaviors and Calculation of Shear Strength of Steel Truss Reinforced Concrete Deep Beams