Abstract:Pulsed power technology has traditionally served in the field of defense technology and is generally operated in a single operation. With the increasing demand in the military and high-energy physics fields, especially in the fields of medicine [1], industry, environmental protection and electromagnetic interference, the demand for high average power is becoming more and more urgent, requiring the pulse source to be in a high repetition frequency operating state. The high-repetition-frequency high-voltage pulse source is a pulse power system that can operate at high repetition frequencies and generate high voltage pulses. Ultra-wideband electrical pulse sources with small size and all solid-state structures are easier to integrate into the system and compatible with other devices. This paper introduces the design and implementation of a high-repetition-frequency high-voltage pulse generating device. The device is mainly composed of a pulse signal source module, a power amplification module and a pulse compression module. The article describes in detail about the pulse signal generation module based on MCU (micro-controller unit) and FPGA (field programmable gatearray) with adjustable frequency adjustable pulse width at the source level, the pulse signal power amplification module based on DSRD (drift step recovery diode) [2] switch, the pulse compression module based on the principle of diode reverse recovery. The final test results show that the device can work at 1MHz repeat frequency, the output pulse peak voltage can be up to 1700V on 50 Omega load, the output pulse rising edge is less than 1 ns, and the half pulse width is up to 1.9 ns. If the pulse compression module is connected, the half pulse width can reach 1.56 ns and the compression ratio can reach 87%.

Design and Implementation of Pulse's Fast Edge Shaping Circuit

Research On A Fast Edge Generaion Technology Of The Digital Pulse

Design of edge rectifier and adjuster for high-speed pulse

A High‐resolution Hybrid Digital Pulse Width Modulator with Dual‐edge‐triggered Flip‐flops and Hardware Compensation

Step Recovery Diodes Pulse Generator in the High Power Laser System

A Driving Pulse Edge Modulation Technique and Its Complex Programming Logic Devices Implementation.

Development of P-C Switch with Adjustable Gap

A Technique on Driving-pulse Edge-modulation and Its Application in Reducing the Switching Voltage Spike of Power Electronic Device

Study on waveform synthesizing technology of controllable high-speed pulse

A Method of the Fast Edge Signal Generation for Oscilloscope Calibration

A Peak Holding Circuit for Fast Narrow Pulse

Design on circuit of fine-tuning control for RZ/R1 pulse-width

A Novel Picosecond-Pulse Circuit Based on Marx Structure and SRD

Design and Implementation of High Speed Pulse Shaped Filter

A Novel Pulse Compression Diode for Picosecond Pulse Generation

Development of the High Repetitive Frequency Solid-State Pulse Generator Based on DSRD

Design of Program Generating Pulse with High-speed and High-Voltage

An Implementation of Step Recovery Diode-Based UWB Pulse Generator

Design, Implementation And Analysis Of Solid-State Megahertz Continuous High-Repetition-Frequency High-Voltage Pulse Source

Pulse Generator of New Energy Saving EDM Pulsed Power Supply

Analysis and Experiment of Nanosecond Pulse Circuit Based on Commercial Si-p-i-n Rectifier Diode