Abstract:The gas-solid vertical single helical ribbon agitated reactor is widely used in the polypropylene industry. The gas flow and mass transfer determine the heat transfer capacity and product quality. In this work, the pressure drop was measured below and above minimum fluidization velocity (umf). Then, the axial and radial dispersion coefficients (DL and DR) were estimated below umf by measuring the step residence time distribution and the stationary radial tracer profiles, respectively. Pressure analysis show the agitation significantly reduces the bed pressure drop, changing the fixed bed below umf and bubbling bed above umf to an agitated bed with a periodic voidage. The DL was proportional to the gas velocity, with little influences of the stirring speed. The radial tracer profiles show the bed is divided by the inner diameter of the helical ribbon into the peripheral ascending region and the central descending region, without gas exchange between them. Furthermore. the tracer profiles in the descending region are classified into two types. For type I, the DR, calculated by the plug flow model with radial dispersion, is proportional to the gas velocity, with little effects of stirring speed. Type II shows uniform profiles due to the deflection of the gas flow toward the low pressure area at the inner diameter of helical ribbon. The causes of the two types are explained by the relative size of particle circulation and gas flux. These two flow regimes are quantitatively clarified with an empirical correlation of Re and Fr as flow regime transition boundary, namely dispersed plug flow and perfect mixing flow. With lower Re and higher Fr, it changes from dispersed plug flow to perfect mixing flow.

On-line Fast Detection and Control of Composition for Binary Gas-Phase Copolymerization of Olefins

Real‐Time Detection of Atmosphere Composition in Three‐Component Gas‐Phase Copolymerization of Olefins

Investigation of a Dynamic Operation Mode of Ethylene Polymerization Process with a Liquid-Containing Fluidized Bed

Precision Copolymerization of CO 2 and Epoxides Enabled by Organoboron Catalysts

Effect of Temperature Switching and Dynamic Phase Equilibrium on Polymer Microstructure in Condensed-Mode Operation

Control of Diffusion/Barrier Effects of Polymer-Coated Particles and the Strengthening of Ethylene Polymerization Reactor

Liquid Containing Particle Polymerization: Ethylene/-Olefin Reaction in a New Environment

On-line Measurements and Model Analysis of Gas-phase Ethylene Polymerization Process in Fluidized Bed Reactor (II)

Stability and dynamic behaviors of gas-phase ethylene polymerization process under condensed mode operation

Regulating the Monomers Composition Ratio Inside the Particle Nanodomains with Induced Condensing Agent and Its Impact on Particle Growth

Continuous Synthesis of Isobutylaluminoxanes in a Compact and Integrated Approach

Collision Characterization of Mixed Hydrocarbon Liquid Droplets with Polyethylene Particles

Experimental Investigation on Mechanisms of Fine Particles Generation for the Borealis Borstar Multistage Olefin Polymerization Process

Stability Analysis Of Ethylene Polymerization In A Liquid-Containing Gas-Solid Fluidized Bed Reactor

Automatic Control System Design and Realization of Latex Polymerization Process

Design and Development of Computer Integrated Control System for Spheripol Propylene Polymerization Unit

Mixing Effects on the Gas Flow and Mass Transfer in a Vertical Single Helical Ribbon Agitated Reactor for Propylene Polymerization

Ethylene polymerization with metallocene/late transition metal combined catalysts

Polypropylene and Ethylene−Propylene Copolymer Reactor Alloys Prepared by Metallocene/Ziegler−Natta Hybrid Catalyst

From Noise to Information: a New Technology of Olefin Polymerization Fluidized Bed Reactor Based on Acoustic Emission

A Study on Olefin Polymer Alloy Based on Propylene