Abstract:The non-associated flow rule (non-AFR), which has been proved with advantages in accurately predicting yield stress components and Lankford coefficients, has different definitions for yield function and plastic potential function. Currently, there are two typical approaches to determine the plastic strain for non-AFR, one is called simple method which still uses the equivalent plastic strain (EPS) to calculate the plastic strain tensor, while the other is called full method which adopts the plastic compliance factor. Many researchers prefer to adopt the simple method in calculating the plastic strain due to its higher computation efficiency and its acceptable accuracy like the full method for some materials. However, the limitation and application condition of the simple method are still ambiguous. In the present work, a restriction for calculating the parameters in plastic potential function for the simple method is clarified and the limitation of the simple method has also been investigated. It is found that if the relative error of the difference between the yield function value and that of plastic potential function is within ±5% and hardening exponent is in the range of 0.1–0.3, the maximum absolute value of the relative error of the stress predicted by the simple method can be controlled less than 1.6%. Besides, an effective approach is introduced to reduce the error of the stress predicted by these two methods, which can improve the applicability of the simple method for those materials with the relative error of the difference between the value of yield function and that of plastic potential function is less than 10%. In order to have deeper understanding about their applicability, the two methods are compared under uniaxial tension along different orientations for AA2090-T3 and AA2008-T4 with the fully implicit return-mapping scheme. Fracture simulations of AA2090-T3 have also been conducted by introducing different methods. The results show that during the loading in transverse direction, the difference of EPSs predicted by these two methods is very small for AA2008-T4, while for AA2090-T3, the EPS predicted by the simple method is almost twice of that calculated by the full method. This further indicates that the applicability of the simple method mainly depends on the characteristics of materials.

Combination Method For The Calculation Of Elastic Constants

Least Square Method for the Calculation of Elastic Constants

An Elementary Formula for Initial Relaxation Modulus from the Creep Compliance of Various Viscoelastic Model

Calculation of Elastic Bond Constants in Atomistic Strain Analysis

Elastic constants of stressed and unstressed materials in the phase field crystal model

Calculations of Single-Crystal Elastic Constants Made Simple.

Arithmetic extraction of elastic constants of cubic crystals from first-principles calculations of stress

A Consistency-Check Based Algorithm for Element Condensation in Augmented Finite Element Methods for Fracture Analysis

Experimental Methodology for Obtaining the Flow Curve of Sheet Materials in a Wide Range of Strains

A New Approach for Calculating Phonon Dispersions and Elastic-Constants of Simple Metals

Calculation of Elastic Modulus of Nanostructural Elements by the Method of Matching of Solutions to Boundary Value Elasticity Problems and Molecular Dynamics Problems

Theory of elastic constants of athermal amorphous solids with internal stresses

A mixed constant-stress smoothed-strain element with a cubic bubble function for elastoplastic analysis using second-order cone programming

New Methods for Prediction of Elastic Constants Based on Density Functional Theory Combined with Machine Learning

A Comparative Study of the Methods for Calculation of Surface Elastic Deformation

True Triaxial Simulation Based on Unified Elastoplastic Finite Difference Method

A New Method to Reliably Determine Elastic Strain of Various Crystal Structures from Atomic-Resolution Images

On the Calculation of Plastic Strain by Simple Method under Non-Associated Flow Rule

An efficient method for calculating thermoelastic properties

Simplified method to identify full von Mises stress-strain curve of structural metals

Numerical methods for the determination of multiple stress singularities and related stress intensity coefficients