MULTI-OBJECTIVE OPTIMIZATION FOR SHEET METAL FORMNIG OF DRAWING WITH SUCCESSIVE RESPONSE SURFACE METHOD

Guangyong Sun,Li Guangyao,Zheng Gang,Gong Zhihui
2010-01-01
Abstract:This paper describes a multi-objective optimization of drawbead geometrical parameters of automotive panel using successive response surface method.The existing response surface method has a low precision in the entire design space,and conventional single-objective optimization design does not provide for multi-objective conditions and has been used to optimize only a single objective.The present method updates the region of interest(ROI) in the design space by panning and zooming.In each ROI,a set of pareto optimal solutions of equivalent drawbead restraint force,are obtained to minimize the defects of crack and wrinkle by combining design of experiments,successive response surface method and multi-objective particle swarm optimization. Through the minimum distance method,a solution with best forming approach is obtained from the pareto optimal solutions,and it is used as the center point of the next region of interest.The optimal drawbead restraint force will be obtained by the iterative procedure.The optimal design geometric parameters of drawbead can be obtained using the optimal drawbead restraint force and genetic algorithm.These optimal parameters can be efficiently used to improve the forming properties of sheet.Numerical examples indicate that the present method has higher precision and practicability compared with the existing techniques.
What problem does this paper attempt to address?