Abstract:As a relatively complex part of aero-engine turbine blades, the integral impeller is characterized by complex space, high steepness, and distortion. An actual five-axis computerized numerical control (CNC) machining process unaffected by the machining quality and accuracy of a large curvature range. Consequently, knowing how to reasonably adjust the feed speed of a path in view of further improving the efficiency has always been difficult. This research adopts the method of combining computer-aided manufacturing (CAM) and CNC and proposes a direct interpolation algorithm for the double non-uniform rational B-spline curves based on the typical characteristics of the integral impeller. First, in the CNC, the integral impeller is divided into high-speed regions and three-dimensional characteristic parameters of the integral impeller in CAM. Second, in the low-speed area, the feature-divided high- and low-speed areas are discretized on the basis of the interpolation period and equal arc length. Then, the low-speed area speed is adjusted to meet the kinematic constraints according to the dichotomous configuration. Finally, the discrete speed is smoothly filtered by the Finite Impulse Response (FIR) filter to be able to meet the dynamic response characteristics of the machine tool. Simulations and experiments show that the algorithm can effectively improve the speed and smoothness of the inlet and exhaust edges of the overall impeller, effectively reduce the calculation amount of the numerical control system, and improve the overall machining efficiency of the impeller under the requirements of machining accuracy.

Analysis of Four Axis Linkage Numerical Control Processing Programming of Impeller Based on UG

Experimental and simulation study on chatter stability region of integral impeller with non-uniform allowance.

Research on the key technique for numerical control grinding arbitrary n-polygon shafts

A Real-Time Dual NURBS Interpolator with Optimised Control of Flexible Acceleration and Deceleration for Five-Axis CNC Machining

Design Method and Numerical Control Machining Principle for an Arbitrary N-Polygon Noncircular Section

A novel tool-path generation method for five-axis flank machining of centrifugal impeller with arbitrary surface blades

An efficient five-axis machining method of centrifugal impeller based on regional milling

A Compound Feedrate Control Method For Multi-Axis Cnc Machining

Judging of Machining Feasibility and Calculation of Midsection for the Five-Axis Milling of Shrouded Centrifugal Impeller

Key Technologies Research For Impellers Machining Based On Nx

Modeling and machining of integral impeller based on NURBS curve

Planning and virtual simulation machining of multi-axis rough machining strategy for micro-integral impeller

Efficient Feedrate Optimization Method for Spline Toolpath Based on Typical Characteristics of Integral Impeller

An accurate surface error optimization for five-axis machining of freeform surfaces

Curve interpolation control strategy for 5-axis linkage computer numerical control machine

Research on Inverse Evaluation Mechanism in Toolpath Generation Based on Global Interpolation Simulation

Software design of numerical control system based on thread technique

An Interpolation Method for the Open CNC System Based on EPM

Preliminary Exploration on Control Theory of Ultraprecision Stage with Large Travel

The Key Process Technology Research of Open Impeller Processing

The Analysis for Real-Time Performance and Realization of CNC System on Middle-Convex and Varying Ellipse Piston Machining