Abstract:The effective solution to avoid machinery damage caused by resonance has been perplexing the field of engineering as a core research direction since the resonance phenomenon was discovered by Euler in 1750. Numerous attempts have been performed to reduce the influence of resonance since the earlier of last century, by introducing a nonlinear structure or a closed-loop control system. However, the existed methodologies cannot eliminate resonance completely even extra problems were introduced inevitably, which means the technical choke-point of resonance-free remains unsolved. Here we propose a designable archetype model, which establishes a mapping between the mechanical properties and its structure. A general inverse method for structure construction is proposed based upon the required property for the system with quasi-zero stiffness of any designed finite order and the zero-stiffness properties. It is shown that an ellipse trajectory tracking of the designed model is the sufficient and necessary condition to satisfy the zero-stiffness property. Theoretical analysis shows that no resonant response happens in a zero-stiffness system to the full-band frequency excitation, or equivalently, the system can completely isolate the energy transfer between the load and environment, when the damping ratio approaches zero. Finally, an experimental rig for the prototype structure is built up according to the sufficient and necessary condition of the zero-stiffness system, for which the special dynamic behaviours are verified through experiments of frequency-sweep and random-vibration as well. Experimental results show that the prototype of the initial vibration isolation frequency of zero-stiffness system is much lower than 0.37 Hz, and the vibration attenuation of the proposed model is about 16.86 dB, 45.63 dB, and 112.37 dB at frequencies of 0.37 Hz, 1 Hz, and 10 Hz, respectively. The distinguished geometric structure of the zero-stiffness system leads to a new inspiration for the design of resonance-free in metamaterial unit and the inverse method can even adapt the design for a more targeted applications based on an arbitrary complex dynamic requirement.

Inverse Problem of Imposing Nodes to Suppress Vibration for a Structure Subjected to Multiple Harmonic Excitations

Imposing points of zero displacements and zero slopes along any linear structure during harmonic excitations

Quenching Vibration by Imposing Nodes on a Plate Subjected to Multiple Harmonics with Distinct Excitation Frequencies

On the Analysis of A Piecewise Nonlinear-Linear Vibration Isolator with High-Static-Low-Dynamic-Stiffness under Base Excitation

Imposing points of zero displacement and zero slopes on a plate subjected to steady-state harmonic excitation

Minimization of the Beam Response Using Inerter-Based Passive Vibration Control Configurations

An Efficient Method to Quench Excess Vibration for a Harmonically Excited Damped Plate

Quenching Vibration on a Harmonically Excited Symmetric Laminated Composite Plate

Vibration suppression of an elastic beam with boundary inerter-enhanced nonlinear energy sinks

Experimental study on active vibration control via inverse modeling

Internal Resonance of a Nonlinear Vibration Absorber

The coupling dynamic characteristics and vibration suppression of a double-beam structure with two linear oscillators installed separately

Application of Dynamic Vibration Absorbers in Structural Vibration Control under Multi-Frequency Harmonic Excitations

Vibration suppression using integrated topology optimization of host structures and damping layers

<i>H</i><sub>8</sub> optimization of cubic stiffness nonlinear energy sink attached to a linear system

Examining the behavior of a two-connected-spring pendulum according to non-resonance and resonance conditions

Structural Vibration Absorption in Multilayered Sandwich Structures Using Negative Stiffness Nonlinear Oscillators

Road to entire insulation for resonances from a forced mechanical system

Generalized Incremental Frequency Method for Topological Designof Continuum Structures for Minimum Dynamic Compliance Subject to Forced Vibration at a Prescribed Low or High Value of the Excitation Frequency

H∞ optimization of cubic stiffness nonlinear energy sink attached to a linear system

Topological design of continuum structures subjected to forced vibration