Abstract:Abstract Recent developments in propulsion systems to improve energy efficiency and reduce hazardous emissions often lead to severe torsional oscillations and aggravated noise. Vibration absorbers are typically employed to palliate the untoward effects of powertrain oscillations, with nonetheless an adverse impact on cost and constrained efficacy over a limited frequency range. Recently, the authors proposed the use of nonlinear vibration absorbers to achieve more broadband drivetrain vibration attenuation with low complexity and cost. These lightweight attachments follow the concept of targeted energy transfer, whereby vibration energy is taken off from a primary system without tuning requirements. In this paper, the design and experimental investigation of a prototype absorber is presented. The absorber is installed on a drivetrain experimental rig driven by an electric motor through a universal joint connection placed at an angle, thus inducing the second-order torsional oscillations. Vibration time histories with and without the absorber acting are recorded and compared. Frequency–energy plots are superimposed to the system nonlinear normal modes to verify the previously developed design methodology, whereas the achieved vibration reduction is quantified by comparing the acceleration amplitudes of the primary system and monitoring the distribution of energy damped in the primary system and the absorber. The absorber prototype was found to lead to significant vibration reduction away from resonance and near resonance with the additional feature of activation over a relatively broad frequency range.

Internal Resonance of a Nonlinear Vibration Absorber

Vibration control through the robust nonlinear absorber with negative stiffness and internal resonance creation

Nonlinear saturation controller simulation for reducing the high vibrations of a dynamical system

Safety action over oscillations of a beam excited by moving load via a new active vibration controller

Finite Element Modeling of Nonlinear Active and Passive Dampers Applied to Vibration Controls

Vibration suppression of an elastic beam with boundary inerter-enhanced nonlinear energy sinks

Analysis of vibration suppression of master structure in nonlinear systems using nonlinear delayed absorber

Vibration Control of Nonlinear Absorber–Isolator-Combined Structure with Time-Delayed Coupling

Saturation correction for a piezoelectric shunt absorber based on 2:1 internal resonance using a cubic nonlinearity

Random Response of Nonlinear System with Inerter-based Dynamic Vibration Absorber

Nonlinear vibration and dynamic stability analysis of an axially moving beam with a nonlinear energy sink

Steady-state response of a viscoelastic beam with asymmetric elastic supports coupled to a lever-type nonlinear energy sink

Study on Dynamic Characteristics of the Bistable Nonlinear Damper

Passive vibration control: a structure-immittance approach

Steady-state responses of mechanical system attached to non-smooth vibration absorber with piecewise damping and stiffness

Design and Experiment of Nonlinear Absorber for Equal-Peak and De-Nonlinearity

Design and validation of a nonlinear vibration absorber to attenuate torsional oscillations of propulsion systems

Control design, analysis, and optimization of fractional-order delayed resonator for complete vibration absorption

Performance, robustness and sensitivity analysis of the nonlinear tuned vibration absorber

Passive Flutter Suppression Using a Nonlinear Tuned Vibration Absorber