Abstract:A series of polyethylene (PE) blends consisting of a linear high density polyethylene (HDPE) and a linear low density polyethylene (LLDPE) with an octane-chain branch density of 120/1000 carbon was prepared at different concentrations. The two components of this set of blends possessed isorefractive indices, thus, making it difficult to detect their liquid–liquid phase separation via scattering techniques. Above the experimentally observed melting temperature of HDPE, Tm = 133 °C, this series of blends can be considered to be in the liquid state. The LLDPE crystallization temperature was below 50 °C; therefore, above 80 °C and below the melting temperature of HDPE, a series of crystalline–amorphous PE blends could be created. A specifically designed two-step isothermal experimental procedure was utilized to monitor the liquid–liquid phase separation of this set of blends. The first step was to quench the system from temperatures of known miscibility and isothermally anneal them at a temperature higher than the equilibrium melting temperature of the HDPE for the purpose of allowing the phase morphology to develop from liquid–liquid phase separation. The second step was to quench the system to a temperature at which the HDPE could rapidly crystallize. The time for developing 50% of the total crystallinity (t1/2) was used to monitor the crystallization kinetics. Because phase separation results in HDPE-rich domains where the crystallization rates are increased, this technique provided an experimental measure to identify the binodal curve of the liquid–liquid phase separation for the system indicated by faster t1/2. The annealing temperature in the first step that exhibits an onset of the decrease in t1/2 is the temperature of the binodal point for that blend composition. In addition, the HDPE-rich domains crystallized to form spherulites which decorate the phase-separated morphology. Therefore, the crystal dispersion indicates whether the phase separation followed a nucleation-and-growth process or a spinodal decomposition process. These crystal-decorated morphologies enabled the spinodal curve to be experimentally determined for the first time in this set of blends.

Application of Crystal Fractionation Technology in the Research of Short-chain Branched Polyethylene

Application of Temperature Rising Elution Fractionation in Polyolefins

Studies on Nonisothermal Crystallization of Ultra–high Molecular Weight Polyethylene in Liquid Paraffin

Characterization of Intramolecular Composition Heterogeneity of Metallocene-Based and Conventional Ethylene-Butene Copolymers Using Tref/Dsc

Calibration curve establishment and fractionation temperature selection of polyethylene for preparative temperature rising elution fractionation

Effect of Short Chain Branching Distribution on Crystallization of Ethylene-Butene Copolymers

Effect Of The Gamma-Form Crystal On The Thermal Fractionation Of Poly(Propylene-Co-Ethylene)

Effect of the γ‐form crystal on the thermal fractionation of poly(propylene‐co‐ethylene)

Separation and identification of ethylene-propylene block copolymer

Preparative temperature rising elution fractionation of polyolefin elastomer and its chain microstructure

CRYSTAF, DSC and SAXS Study of the Co-Crystallization, Phase Separation and Lamellar Packing of the Blends with Different Polyethylenes

6 Application of high resolution FTIR spectroscopy in structural characterization of polyethylene and ethylene copolymers

Study on thermal behavior of impact polypropylene copolymer and its fractions

Temperature rising elution fractionation of polypropylene produced by heterogeneous Ziegler-Natta catalysts

Enhanced characterization of the chemical structure of high-density polyethylene by size exclusion/thermal fractionation on poly(styrene-co-divinylbenzene) columns

Infrared Spectroscopic Characterization of the Crystallinity and the Hydrocarbon Chain Packing of the Polyethylene Segments in Poly(ethylene-co-dimethylaminoethyl Methacrylate)

Probing Liquid‐Liquid Phase Separation of a Polyethylene Blend with Thermal Analysis

Rheological Properties and Crystallization Behaviors of Long Chain Branched Polyethylene Prepared by Melt Branching Reaction

Molecular dynamics simulation of melting and crystallization processes of polyethylene clusters confined in armchair single-walled carbon nanotubes

Liquid–liquid Phase Separation in a Polyethylene Blend Monitored by Crystallization Kinetics and Crystal-Decorated Phase Morphologies

Crystallization And Melting Of Poly(Ethylene Oxide) Confined In Nanostructured Particles With Cross-Linked Shells Of Polybutadiene