Abstract:Nickel-based superalloy IN713C produced through investment casting route is widely used for turbocharger turbine wheels in the automotive industry. The produced microstructure and microtexture are not homogeneous across the turbine component due to geometrical factors and localised cooling rate during the casting process, which give rise to inhomogeneous deformation during service. In the present paper, two kinds of in-house fatigue tests, Low Cycle Fatigue (LCF) and High Cycle Fatigue (HCF), were conducted at 600 °C in attempt to simulate the actual fatigue conditions experienced by turbine wheels in turbocharger. From Geometrically Necessary Dislocation (GND) distributions and strain analyses, it is concluded that microstructure heterogeneity such as carbide precipitates distribution within dendritic structure network determine the failure micromechanics during LCF tests. In the early stage of LCF loading, crack principally initiated within near surface carbides that have been oxidised during high temperature exposure. The higher GND density at the tip of carbide precipitates due to oxidation volume expansion are found to facilitate easy cracks initiation and propagation. Moreover, the cluster-like carbides network and its distribution can accelerate oxidation process and crack growth effectively. Furthermore, in the later stage of crack propagation during LCF, the weak interdendrite areas rotate to accommodate increased strain leading to faster cracks propagation and hence final catastrophic failure. Serial section technique for 3-D visualisation was employed to investigate the crystallographic grain orientation correlation with fracture mechanics during HCF loading. It appears that the microtexure and grain orientations are more critical than the alloy microstructure in an area with a relatively uniform carbides distribution and weak dendrite structure where HCF failure occurred. Based on the slip trace analysis, it was found that most faceting occurred in Goss grains (<110>//LD) and on slip system with the highest Schmid factor. It is concluded that cracks were initiated on planes with high Schmid factors and assisted by the presence of porosity.

Analysis on Micro Cracks Defect of Francis Turbine Band Casting Based on Solidification Process Simulation

Simulation Analysis of Thermal Stress During Casting Process of Large-Sized Alloy Steel Ingot

Thermal Stress Analysis of the Solidification Process of Francis Turbine Band Casting

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

Application of Modeling and Simulation of Thermal Stress in Solidification Process of a Heavy Steel Casting

Numerical Simulation of Temperature Field and Stress Field for and Axial Crack Analysis of Heavy-wall Centrifugally Cast Hollow Bloom

Numerical simulation analysis of thermal stress fields during solidification of steel casting

Numerical Simulation of Solidification Process of Gas Turbine Blade in Investment Casting

Study on Hot Crack for the Casting of Bolster and Side Bearer by Numerical Simulation

Thermal stress simulation considering mechanical interaction between casting and mold

A Study on the Numerical Simulation of Thermal Stress During the Solidification of Shaped Castings

Numerical Simulation of Central Shrinkage Crack Formation in a 234-T Steel Ingot

Hot Cracks in Camshaft Casting: Initiation and Propagation

Microstructure Simulation to the Solidification Process of Single Crystal Guide Vane

Numerical Simulation of Thermal Stress During Directional Solidification of Simple Hollow Turbine Blades

Macro and Micro Modeling on Conventional and Unidirectionally Solidified Investment Castings

Analysis of laminated crack defect in the upsetting process of heavy disk-shaped forgings

Thermomechanical Analysis and Optimisation for Beam Blank Continuous Casting

Analysis of Fatigue Cracking for Turbine Blade

Numerical Simulation of the Thermo-Mechanical Process for Beam Blank Continuous Casting

The Effects of Microstructure and Microtexture Generated During Solidification on Deformation Micromechanism in IN713C Nickel-Based Superalloy