Abstract:Development of a laboratory selected zeolite into an industrial zeolite-based catalyst faces many challenges due to the scaling-up of reaction which requires many upgrades of the as-prepared catalyst such as an enhanced physical strength. To meet this requirement zeolite powders are normally mixed with various binders and then shaped into bulky bodies. Despite the fact there are a lot of reports on the positive features brought by the shaping treatment, there is still a great need to further explore the zeolite properties after the binder introduction. In this case, a lot of studies have been continuously conducted, however, many results were limited due to the usage of much smaller laboratory samples rather than a real factory plant, and more importantly, the maximal/minimal proportion of zeolites in the shaped catalyst. In this research, our shaped catalysts are based on nano-H-ZSM-5 zeolites and alumina (γ–Al2O3) binder while keeping the zeolite content to a maximum. H-ZSM-5 samples and Al-H-ZSM-5 samples are compared in the designed methanol-to-hydrocarbons reaction. With a reduced weight-hourly-space-velocity (WHSV = 1.5 h−1) and a higher reaction pressure (6 bar) favorable for aromatization, together with the tailored instruments for catalyst volume scale-up (20 g samples are tested each time), our tests focus on the early period catalytic performance (during the first 5 h). Unlike a normal laboratory test, the results from the scaled-up experiments provide important guidance for a potential industrial application. The role of the γ–Al2O3 introduced, not only as binder, but also performing as co-catalyst, on tailoring the early time product distribution, and the corresponding coke deposition is systematically investigated and discussed in details. Notably, the Si/Al ratio of H-ZSM-5 still has a decisive influence on the reaction performance of the Al-H-ZSM-5 samples.

The Effect of Nano ZnO on the Surface Structure and Catalyst Activity of H4SiW12O40-La2o3/Nano ZnO:γ-Al2O3

Effect of support texture properties on Ni-Fe/γ-Al_2O_3 catalyst structure and catalytic performance for CO methanation

Effects of Pore Structure on Methanol Selectivity in Carbon Monoxide Hydrogenation

Effect of Si Content on the Performance of Direct Synthesis of Dimethyl Ether over Slurry CuZnAl Catalyst Prepared by Complete Liquid Phase Technology

Complete Liquid Phase Preparation and Characterization of CuZnAlSi Catalysts for DME Synthesis in Slurry Reactor

Effect of La modified Cu/ZrO2 catalysts on alcohol synthesis

Effect of Composition of Raw Materials on Structure and Dimethyl Ether Synthesis Activity of Cu-Zn-Al Catalyst Prepared by Complete Liquid Phase Method

Effect of Residual Sodium on the Catalytic Activity and Stability of Cu-Based Methanol Synthesis Catalyst

A Study into the γ-Al2O3 Binder Influence on Nano-H-ZSM-5 via Scaled-Up Laboratory Methanol-to-Hydrocarbon Reaction

Optimization and understanding of ZnO nanoarray supported Cu-ZnO-Al2O3 catalyst for enhanced CO2 -methanol conversion at low temperature and pressure

Synthesis of a Cu@ZnO1-x/Al2O3 Catalyst with High-Density ZnO1-x-Cu Interfacial Sites for Enhanced CO2 Hydrogenation to Methanol

Investigation of Cu-ZnO/SiO2 Catalysts for CO2 Hydrogenation: Effect of SiO2 Support with Different Porous Structure

A High Activity Cu/ZnO/Al2O3 Catalyst for Methanol Synthesis: Preparation and Catalytic Properties

Surface active structure of ultra-fine Cu/ZrO2 catalysts used for the CO2+H2 to methanol reaction

Effect of the Si/Al Ratios of Nanocrystalline HZSM-5 Zeolite on the Performance in Catalytic Conversion of Ethanol to Propylene

Micro-mesoporous Composite Molecular Sieves H-ZSM-5/MCM-41 for Methanol Dehydration to Dimethyl Ether: Effect of SiO2/Al2O3 Ratio in H-ZSM-5

Size Effect of Cu Particles on Interface Formation in Cu/ZnO Catalysts for Methanol Synthesis

Influences of preparation methods of ZrO2 support and treatment conditions of Cu/ZrO2 catalysts on synthesis of methanol via CO hydrogenation

Influence of SiO2/Al2O3 ratio in HMCM-22 on catalytic performance of Cu2ZnO2Al2O3/HMCM-22 for synthesis of dimethyl ether

Synthesis, characterization and activity pattern of Cu–ZnO/ZrO2 catalysts in the hydrogenation of carbon dioxide to methanol

The Synergistic Effect Between ZnO and ZnCr2O4 on the Catalytic Performance for Isobutanol Synthesis from Syngas