Influences of various cutting parameters on the surface roughness during turnings stainless steel

Zhou Zhimin,Zhang Yuanliang,Li Xiaoyan,Zhou Huiyuan,Sun Baoyuan
DOI: https://doi.org/10.1134/S1063771011010209
2011-01-01
Acoustical Physics
Abstract:This paper presents an investigation of the process factors affecting the surface roughness in ultra-precision diamond turning with ultrasonic vibration. Stainless steel was turned by diamond tools with ultrasonic vibration applied in the feed direction with an auto-resonant control system. Surface roughness was measured and compared along with the change of the cutting parameters. The relation curves between the cutting parameters and surface roughness were achieved by comparing the experimental results with different cutting speeds, feed rates, cutting depths. Experimental results indicate that cutting parameters have an obvious effect on the surface roughness. The conclusions are draw in given conditions, the smaller amplitude of the vibration, the worse the surface quality and the higher vibrating frequency, the better surface quality, and the deeper the cutting depth and the more the feed rate, the worse the surface quality. Among these parameters, the feed rate was the most important factor on surface quality.
What problem does this paper attempt to address?