Abstract:Full three-dimensional numerical simulations are employed to investigate the flows over inclined trapezoidal low-aspect-ratio plates at low Reynolds numbers, aiming to understand the unsteadiness induced by the interaction between the trailing vortical wake structures originating from the swept edges, and those from the leading and trailing edges. The flows past eighteen different plate geometries in three broad sets are simulated to study the influence of aspect ratio, taper angle and angle of attack on the wake vortices and the force coefficients. Both taper ratio and angle of attack of plates with the same area are found to have a broadly predictable influence on the wake stability and asymptotic forces. Smaller taper ratios result in lower maximum lift, while an increase in the angle of attack results in a reduction in the differences in maximum lift. Two distinct modes of periodic unsteady flow with significant differences in frequency are observed. The corresponding vortex-shedding mechanisms are analysed with the aid of $Q$ -criterion isosurfaces and streamlines. A low wake frequency is observed at small taper angles when there is relative independence between the von Kármán vortices originating from the leading and trailing edges, and weak swept-edge vortices. The dominant Strouhal number in this state is approximately 0.09. When the taper angle or angle of attack increases, the flows over the swept edges form stronger trailing vortex structures which interact strongly with the leading-edge vortices, combining to produce a regular stream of vortex loops shed into the wake. In this regime, the dominant Strouhal number increases to approximately 0.14–0.18. Higher Reynolds numbers and/or angles of attack result in a loss of centre plane reflection symmetry in the wake. The aerodynamic forces have been quantified as a function of the problem parameters and plate geometry.

Flow Field Characteristics of Multi-Plates Interference in Descent

Studying of Multi-Plume Interference Effects for Attitude-Control Thruster with DSMC Method

Numerical Study of Violent Impact Flow Using a CIP-Based Model

Vortex Separation and Interaction in the Wake of Inclined Trapezoidal Plates

Numerical Simulation of Two Coalescing Turbulent Forced Plumes in Linearly Stratified Fluids

Investigations of Multi-Stage Turbomachinery Flow Based on Mixing Plane Models and Unsteady Simulations

Numerical Study of Multi-Plates Separating Flow and Characteristics

Numerical simulation of unsteady characteristics of large flow rate jet interference

Unsteady Supersonic Flow for a Plate Undergoing Three-Stage Sinking Motion

Flow Interference Investigation of Multi-Square Prisms under Fluid–structure Interaction. II. Flow Field Phenomenology of Side-by-side Square Prisms

Investigation of Practical Flow Control Methodologies with RANS/LES Hybrid Methods

Interaction of unsteady separated flow over multi-bodies moving relatively in the same flow field

Numerical Study of Flow Characteristics Behind a Stationary Circular Cylinder with a Flapping Plate

Numerical Studies of Undulation Control on Dynamic Stall for Reverse Flows

Study of Transonic Separated Flows with zonal-DES Based on Weakly Non-linear Turbulence Model

Dynamics of an Inverted Flexible Plate in A Uniform Flow

Numerical analysis of interaction between turbulent structures and transient sheet/cloud cavitation

Numerical Investigation of Control Surfaces Deflection

The Flow Interference Investigation of Multi-Square Prisms under Fluid–structure Interaction. I. Proximal Wake Characteristics of Tandem Square Prisms

On Interference Between Two Circular Cylinders in Staggered Arrangement at High Subcritical Reynolds Numbers

Dynamic Interference of Two Anti-Phase Flapping Foils in Side-by-side Arrangement in an Incompressible Flow