Abstract:<p>Large span portal-rigid frames with tapered sections in low-rise metal building system are often used in industrial and commercial buildings. The drift of such portal-rigid frames induced by the wind load needs to be smaller than a prescribed limit, and at the same time the frames should be as light as possible for cost-effectiveness. To this end, structural optimization of such portal-rigid frames subjected to the wind-induced drift constraint is required. However, little research for optimization of the large span portal-rigid frame with tapered sections has been reported. This paper proposed a procedure for structural optimization of such portal-rigid frames by adopting the Optimality Criteria (OC) method. Based on an aerodynamic database of the measured wind pressure from a wind tunnel test, several forms of the Equivalent Static Wind Load (ESWL) acting on a large-span portal-rigid frame were evaluated by the Gust Loading Factor (GLF), Load Response Correlation (LRC) and Proper Orthogonal Decomposition (POD) method. The method of virtual-work was utilized to construct the wind-induced drift or displacement. An effective iteration algorithm was derived for the minimum weight optimization of the frame while all wind-induced drift constraints were satisfied. The wind resistant structural optimization for the large-span rigid frame with taped section were conducted when it was bore by different forms of ESWL (GLF based, single objective and multiple objective ESWLs), and their optimized results were multi-compared in the form of the optimized total weight and the height of the optimized structural members. The effects of the connection stiffness at semi-rigid joints and the stiffness of support restraints on the optimized results are also investigated. Finally the global optimality property of the proposed OC method adopted for the optimized case in this paper was also discussed and verified. Optimized results show that the OC optimization procedure proposed in this paper is very effective for the optimization design of large-span portal-rigid steel frames with tapered sections under wind-induced drift constraints.</p>

Rules of drift decomposition and drift-based design of RC frames*

RULES OF ELASTOPLASTIC DRIFT DECOMPOSITION OF RC FRAMES AND THE TARGET DRIFT OF MEMBERS

Deformation Decomposition Rule of RC Frame Core Tube Structures

Story-based Stability Design of Frames

Research on Shear Properties of Top Story T-Joints in R.C. Frame Structure with Special-Shaped Columns under Low Cyclic Reversals

Modified Solution Strategy Of Framed Structures For Geometrically Nonlinear Analysis

A Comparative Study of Alternative Approaches for Stability Design of Steel Frames

Design Approach of Elastic-Plastic Story Drift for Concrete-filled Steel Tubular Composite Frame

Displacement-based deformation capacity design method of RC columns

Discussion on rational model of RC frame structures without basement

Reinforcement design method of RC box girder subjected to combined torsion

Reliability-based multi-scale design optimization of composite frames considering structural compliance and manufacturing constraints

Rollover crashworthiness analysis and optimization of bus frame for conceptual design

Optimization design of large span portal-rigid steel frame with tapered sections under wind-induced drift constraint

Numerical Models to Predict the Collapse Behavior of RC Columns and Frames

A concurrent design method for functional tolerance and structure based on the principle of decomposition and reconstitution

Reciprocal Frame (RF) Architecture Design Based on Statistical Analysis of Geometrical Form Parameters from Built Cases and Parametric Simulations

A novel structural detailing for the improvement of seismic and progressive collapse performances of RC frames

Design method of RC beam-STCC column joint connected with ring beam

STUDY ON DESIGN METHOD TO RESIST PROGRESSIVE COLLAPSE FOR REINFORCED CONCRETE FRAMES

Matrix-based predictive model of residual drift and analytical resilience design approach for self-centering columns