Dynamic Viscoelasticity of Composites with Different Specimen Dimensions Under High Loads

ChengHong He,Zhang Zuoguang,Yubin Li,Sun Zhijie

DOI: https://doi.org/10.3321/j.issn:1000-6893.2007.06.016

2007-01-01

Abstract:The EPLEXOR 500 dynamic mechanic thermal analysis (DMTA) was used to investigate the effects of static and dynamic loads on storage modulus and loss tangent of T300/epoxy 648 in three-point bending. The results showed that the storage modulus decreases with increasing dynamic load and increases with increasing static load, and the loss tangent decreases with increase of any one of these two loads. These effects can be enhanced, especially for storage modulus, with decreasing the span or increasing the thickness or width of specimen. Such results are originated from the "suppression effects" of all the static stresses on dynamic strain. These suppression combined with the effect of additional shear stress leads to the fact that the storage modulus increases with the increase of span, decreases of thickness and width when the static-dynamic load ratio is below a certain transition zone, while the law will turn to the reverse when the ratio is above this zone.