Abstract:Nowadays, the commonly used large view calibration methods usually have the problems of low measurement accuracy, big on-site operation limitation, or high tolerance requirement for target preparation. In order to resolve the previously mentioned issues, a two-step calibration method for the interior and exterior parameters of multicameras is proposed based on the principle of industrial close-range photogrammetry. In the first step, by using a small-scale cross target at the closer range, the interior parameter of the front section of the camera is calibrated based on the pyramid method. In the second step, by setting a proper number of serialized targets at the further range of the measured area, the exterior parameter is calibrated based on space resection with multi-image. Finally, the interior and exterior parameters are all optimized by using the bundle adjustment method to get accurate measurement results. A number of experiments are performed to verify the feasibility and accuracy of this proposed method. As per the experiment results, with a camera resolution of $2448 \times 2048$ pixels, the reprojection error is less than 0.11 pixels. For the measuring volume of $10.0 \times 8.4 \times 3.6$ m, the maximum absolute error of 3-D measurement is 0.42 mm. The measurement error for the flapping angle of rotor whose diameter is 10 m is less than 4.5%. By using this method, the interior parameter can be collected in the laboratory, while the exterior parameter can be collected in the open field separately. This method has high practicality under the actual engineering working environment.

A Method for Improving the Ranging Accuracy of Large Visual Angle 2D Triangulation Range Finder with Dual Lens

High-Accuracy Method for Measuring Two-Dimensional Angles of A Linear Guideway

Research on high-speed and non-contact angle detection based on laser measurement

Study on the Analysis for Error in Triangular Laser Measurement and the Method of Improving Accuracy

A New Method for Increasing Accuracy of Distance Measurement Based on Single Visual Camera

Measurement Error Analysis and Accuracy Enhancement of 2D Vision System for Robotic Drilling

Coarse Error Analysis and Correction of a Two-Dimensional Triangulation Range Finder

Calibration of a Single-Point Laser Range Finder and a Camera

A Scheme for Enhancing Precision in 3-Dimensional Positioning for Non-Contact Measurement Systems Based on Laser Triangulation

Automatic Calibration Between Multi-Lines LiDAR and Visible Light Camera Based on Edge Refinement and Virtual Mask Matching

A Two-Step Calibration Method for Vision Measurement with Large Field of View

Practical Retrace Error Correction in Non-Null Aspheric Testing: A Comparison

Adaptive Zoom Distance Measuring System of Camera Based on the Ranging of Binocular Vision

Simultaneous two-dimensional velocity and distance measurements based on laser triangulation

High Precision and Large Dynamic Range Measurement of Laser Triangulation Displacement Sensor Using Diffraction Grating

An extrinsic calibration method for binocular cameras and swing 2D laser rangefinder

High Accuracy Positioning Method Based on 2D Imaging for the Coordinates of the Center of a Sphere

Camera Calibration Algorithm for Long Distance Binocular Measurement

A new 3D high accuracy optical coordinates measuring technique based on an infrared target and binocular stereo vision

Target Image Matching Algorithm Based on Binocular CCD Ranging

Improving Measurement Accuracy of Deep Hole Measurement Instruments through Perspective Transformation