Abstract:Radial shaft sealing rings (RSSR) are important machine elements used in rotating and oil lubricated systems. Their main task is to prevent oil from exiting the system and dirt particles from entering the system. When this function is not fulfilled, a leakage can occur and cause excessive damage after certain operating times, such as gear failure due to insufficient lubrication. This is the reason for the high level of current research interest in seals. The sealing function of RSSR occurs in the contact area between the sealing lip and the shaft. The contact takes place over a very small contact width of approximately 1 μm. These extremely small dimensions and the complex relationships between the functional influencing variables on the radial shaft sealing system make it difficult to simulate wear on the sealing ring. The energetic consideration of the wear process offers the possibility of quantifying influencing variables more easily by their energetic contribution, which can be determined experimentally. Based on experimentally measured total friction moments, and with the help of a semi-analytical (SA) solid contact model based on the half-space theory, this paper presents a modelling approach for the calculation of wear at the sealing ring. The model presented in this work differs from the existing models in two ways. The first particularity is the coupling of SA method with finite element method (FEM) for the resolution of the contact between the sealing lip and the shaft, allowing a fine discretization of the contact zone (by SA method) and the consideration of the structural behavior (by FE method). The SA method compared to the commonly used FEM presents a great saving in computation time. The second particularity is the use of the real data obtained during the wear tests. Most existing simulation models are based purely on contact pressure. This means that through the contact pressure obtained by simulation and a given sliding distance value, a friction energy will be estimated which will be used in a next step using a wear model such as Archad’s to calculate the wear rate. In this publication the value of friction energy was obtained directly on an experimental basis and a more appropriate wear law, such as Fleischer’s, taking into account the friction conditions, was used to estimate the wear rate.

Prediction of Seal Wear with Thermal-Structural Coupled Finite Element Method

Analytical and Experimental Method of Thermal Load Estimation for Seals in Transmission of Vehicle

Experimental Research and Finite Element Analysis of Seals in the Pressure Compensator

The Wear of Seal Fins During High-Speed Rub Between Labyrinth Seal Fins and Honeycomb Stators at Different Incursion Rates.

Analysis of material fault of O-ring seal in aircraft cylinder

Analysis of Friction and Wear Properties of Friction Ring Materials for Friction Rings under Mixed Lubrication

Wear modelling and sealing performance prediction of C/C composite finger seal

Study on the prediction of high-speed rotary lip seal wear in aero-engine based on heat-fluid-solid coupling

Thermal-stress-wear coupled characteristics of oil seal in airframe rod end-bearing

Coupling Analysis of Frictional Heat of Fluid Film and Thermal Deformation of Mechanical Seal End Faces

Long-term sealing performance evaluation and service life prediction of O-rings under thermal-mechanical coupling conditions

Sealing performance assessments of PTFE rotary lip seals based on the elasto-hydrodynamic analysis with the modified archard wear model

Prediction of the Contact Behavior of Stepseals: Experimental and Numerical Investigations

Thermo-mechanical coupling analysis of the end faces for a mechanical seal under dry friction

Friction Energy-Based Wear Simulation for Radial Shaft Sealing Ring

Investigation of local hot spots in sealing rings with different sealing materials

Numerical Calculation Method of Multi-Lip Seal Wear under Mixed Thermal Elastohydrodynamic Lubrication

Study on the Performance of Reciprocating Seals under the Coupling Effect of Elastohydrodynamic Lubrication and Rubber Wear

Frictional Study on 30CrNi2MoVA Steel Based on Experiments and Finite Element Simulation: Wear Prediction

Study on the Wear Performance of V-combined Tandem Seals

Numerical Simulation Model of Reciprocating Rod Seal Systems with Axial Wear Texture on Rod Surface