Abstract:GIS (Gas Insulated Switchgear) is widely used in power system for its advantages. However, there may have some faults in the GIS with the running time increasing. Mechanical defects are the main reasons lead to circuit breaker failure. Therefore, this paper proposed a method to analyze the mechanical state of GIS circuit breaker. The operation process of the transmission mechanism of the circuit breaker. The GIS circuit breaker mechanical vibration system was built in the laboratory. A vibration acceleration sensor was used to detect the vibration signal during the opening and closing operation of the circuit breaker. To study the change rule of mechanical state with the increasing operation times, the vibration tests of the GIS circuit breaker were carried out for more than 100 times on two GIS circuit breakers. The evolution law of the vibration signals was extracted based on the time-frequency analysis. According to the analysis results: at the first 50 times closing operation, the vibration signal is scattered mainly over 400-600Hz, 800Hz and 1100-1300Hz. With the increase of the closing times, the amplitude of vibration signal around 800 Hz gradually decreases. The similarity with the first operation is decreasing with the number of operation increases. After operating for 50 times, the similarity tends to be stable. The similarity of each device is only valid for the certain device. Each equipment needs to be checked before using these similarities. The proposed method lays a foundation for detecting mechanical aging and predicting the life of the circuit breaker.

On-Line Monitoring System for Switching Synchronization of Ultra-High Voltage Circuit Breaker in GIS

GIS Mechanical State Identification and Defect Diagnosis Technology Based on Self-Excited Vibration of Assembled Circuit Breaker

Iterative Online Fault Identification Scheme for High-Voltage Circuit Breaker Utilizing a Lost Data Repair Technique

Research on the Replacement of Circuit Breaker in 550 kV GIS

A Novel On-line Monitoring Method for Three Phase Synchronization of Medium Voltage Vacuum Circuit Breaker

Mechanical Condition Monitoring for High Voltage Circuit Breakers

STUDY OF SWITCHING SYNCHRONIZATION OF HIGH VOLTAGE BREAKERS BASED ON THE WAVELET PACKETS EXTRACTION ALGORITHM AND SHORT TIME ANALYSIS METHOD

Mechanical State Detection of GIS Circuit BreakerBased on Vibration Characteristics

On-line Monitoring Method for Mechanical Characteristics of Vacuum Circuit Breakers

Hardware Design of Online Monitoring Device for the High-voltage Vacuum Circuit Breaker

Development of On-line Monitoring System of Medium Voltage Switchgear

Research on Fault Diagnosis Method Based on Vibration Signal for High Voltage Circuit Breaker

Online monitoring and diagnosis of high voltage circuit breaker faults: feature extraction analysis of vibration signals

Measurement and Analysis of the Radiated Electric Field Excited by Switching Operation of 330 kV GIS

Transient Voltage UWB Online Monitoring System for Insulation Failure Analysis and Fault Location of GIL

Insulation Fault Diagnosis of Circuit Breakers Based on Waveform Characteristics of Radiated Electric Field Due to Switching Operation

On line monitoring of operation time for SF_6 high-voltage circuit breakers based on wavelet algorithm

Research on Partial Discharge Breakdown Location Technology of 1000kv GIS in Field Test

Research on Fault Diagnosis Technology of AC Medium Voltage Vacuum Circuit Breaker Based on Wavelet Packet

Automated monitoring and analysis for high voltage circuit breaker

On-line Condition Monitoring System of Medium-Voltage Switchgear