Abstract:Industrial pulverized coal boilers play an important role in the use of distributed energy, but still suffer from severe pollutant emissions, combustion instabilities and poor fuel adaptabilities. In this paper, numerical simulation and full-scale experiments were carried out to study the recirculating and combustion characteristics of a novel reverse-jet swirl pulverized coal burner with an adding bluff body and flexibly adjusted secondary air. The axial velocity stagnation contour and the out-of-plane vorticity contour were used to characterize the recirculation structure of reverse swirl flows. The original design achieves a moderate char burnout with the carbon content in fly ash to be 18.63% under a residence time of 0.158 s, which demands for the further improvements. However, if only the injection velocity of the secondary air is increased by halving the axial range of the swirl vane, the recirculating flow is strengthened to such an undesired degree that coal ignition appears in the primary air pipe, the burner-wall overheating and near-wall particle enrichment can occur. To overcome it, a bluff body was incorporated with the enhanced secondary air flow. The recirculation zone was restricted downstream the bluff body, thus eliminating possible early coal ignition. Besides, the width of the recirculating flow is broadened, resulting in a more stable combustion with a less fluctuated pressure signal at the furnace exit. The near-wall coal particle concentration is reduced by approximately 90%. As a result, the use of bluff body decreased the carbon content in fly ash to 8.55% by increasing the coal particle residence time to 0.171 s. In addition, the NO concentration at the burner outlet is decreased by 8% owing to a longer coal particle residence time in the reducing environment.

Dynamic Characteristics of the Reciprocal Porous Media Combustion System with Heat Recirculation

Excess Enthalpy Combustion Characteristics in Reciprocal Porous Media Combustion System with Heat Recirculation

Feasibility and Pressure Dynamics of Novel System for Generating High Temperature Air

Combustion Characteristics of Low Calorific Gas in Reciprocal Flow Porous Media Burner

Experimental Investigation on Critical Slowing Down of Premixed Combustion in a Backward-Facing Step Combustor

Characterization on Ignition and Volatile Combustion of Dispersed Coal Particle Streams: in Situ Diagnostics and Transient Modeling

Pressure Drop Profiles in Porous Media Combustion System With Reciprocating Flow

Temperature Profiles of Porous Media Combustor with Reciprocating Flow System

Experimental Research on Gas/solid Temperature Distribution in Porous Media Premixed Combustion

Experimental Study on Premixed Combustion in Two-Layer Porous Media with Embedded Heat Exchangers

Heat integration and dynamic characteristics analysis of coal pyrolysis to acetylene

Heat recirculation and heat losses in porous micro-combustors: Effects of wall and porous media properties and combustor dimensions

Recirculating Structures and Combustion Characteristics in a Reverse-Jet Swirl Pulverized Coal Burner

Temperature and Heat-recirculation Distribution in Micro-scale Combustion

Experimental and Numerical Study on the Combustion Characteristics of Premixed Methane/Air in Porous Media Burner

Numerical Study of the Combustion Characteristics of an 800-1200 kW High-Power Porous Media Combustor at Atmospheric Pressure

Experimental investigation on dynamic characteristics of methane/air combustion in double‐layer pellets porous media

Gas and solid phase temperature measurements of porous media combustion

ICOPE-15-C047 Dynamics of Non-premixed Flames with Modulations in the Air Flow for a Bluff-body Burner

Numerical Study on the Characteristics of Methane Hedging Combustion in a Heat Cycle Porous Media Burner