Abstract:Displacement measurement is a major concept in the daily maintenance and failure assessment of engineering structures. Vision-based systems offer a cost-effective, simple alternative for noncontact displacement measurement. However, its measurement is challenging because of the errors induced by camera instability (thermal effects on camera sensor and camera motion). Researchers have tried to compensate for the errors induced by camera instability in displacement calculation methods by placing fixed objects in the background. However, remotely-located objects in the background cannot fully allow for camera rotations. Supplementary sensors can be employed to measure the camera motion in six degrees of freedom (6-DOF), although this method is unable to compensate for thermal effects on camera sensor. This paper presents a dual-view system that can compensate for the camera instability by using a camera, a beam splitter, a convex lens, and a photomask. The beam splitter and convex lens enable the camera to capture dual-view data and measure the instability of the system by using the photomask. In laboratory tests, the Root Mean Squared Error (RMSE) of the displacements measured by the proposed system did not exceed 0.05 mm under the conditions of drastic temperature variations and strong winds. Outdoor tests showed that the reflection of sunlight on the objects will seriously affect the practical performance of the proposed system, and a robust localization method for the photomask is necessary. The measurement scheme design for the track structure vibration of high-speed railways proved the acceptable engineering practicability and installation flexibility of the dualview system.

Measuring technology of rail vehicle's offset caused by vibration

Vision-Based Position Deviation Measurement of Rail Corrugation Chord Measuring Points under Bi-Linear Laser Assistance

A New Laser Displacement Sensor Based on Triangulation for Gauge Real-Time Measurement

An Automated System for Position Monitoring and Correction of Chord-Based Rail Corrugation Measuring Points

Pose Alignment of Aircraft Structures with Distance Sensors and CCD Cameras

Displacement Identification by Computer Vision for Condition Monitoring of Rail Vehicle Bearings

Improving Displacement Measurement Accuracy by Compensating for Camera Motion and Thermal Effect on Camera Sensor

Identification of track irregularities with the multi-sensor acceleration measurements of vehicle dynamic responses

Motion Deviation Rectifying Method of Dynamically Measuring Rail Wear Based on Multi-Line Structured-Light Vision

Vision-based Structural Displacement Measurement: System Performance Evaluation and Influence Factor Analysis

Track inspection device mounted on commercial train for urban maglev

Real-time and Accurate Rail Wear Measurement Method and Experimental Analysis.

A Data Splicing Method for Measuring Rail Corrugation Under Pitching Vibration

Design and evaluation of a remote measurement system for the online monitoring of rail vibration signals

Online Detection System for Wheel-Set Size of Rail Vehicle Based on 2d Laser Displacement Sensors

Experimental Study on the Potential of Vehicle’s Attitude Response to Railway Track Irregularity in Precise Train Localization

Lateral Vibration of A Maglev Track Inspection Vehicle and Its Effect on Measurement Accuracy of Maglev Track Geometry Parameters

Deviation rectification for dynamic measurement of rail wear based on coordinate sets projection

Track Irregularities Estimation Based on the Vibration of Car-Body

Research on Motion Stability Measurement of Guide Rails Based on Position Sensitive Detector

A NOVEL ACCELEROMETER-BASED METHOD FOR ESTIMATING THE TRANSVERSE DISPLACEMENT OF LIGHT PIER RAILROAD BRIDGES AND SHAKING TABLE TEST VERIFICATION