Abstract:Catalyzed diesel particulate filters (CDPFs) are crucial technologies to control the particulate emissions from diesel engines. While obvious drops in filtration efficiencies (FEs) for particle number (PN) occur during the passive regeneration of CDPFs, which can lead to the deterioration of transient emissions. Therefore, in this study, a quasi-2-D model, including a fluid dynamic model, a back-diffusion model, a global kinetic model and a basic filtration model, was established for describing the PN-filtration-behavior of a CDPF. An extended filtration model was developed based on the soot fragmentation hypothesis, considering the effects of the particle diameter, soot load, exhaust gas temperature and flow velocity. An 8.8L, heavy duty diesel engine equipped with a commercial DOC and a CDPF was employed. The particle number and size distributions before and after the CDPF were determined with an engine exhaust particle sizer (EEPS) under eight operating conditions. The extended filtration model was calibrated with the test data, and the model results aligned with those of experiments with a maximal error less than 5% and an average error less than 1%. Then, the undetermined parameters in the extended filtration model were evaluated under the eight working conditions, and distinct regularities were observed among these parameters. The time-dependent PN-filtration-behavior of the tested CDPF was also explored based on the model. According to the model predictions, it was found that the PN-filtration-behavior of a CDPF was different from that of a DPF, and the PN-FE of a CDPF might be still unsatisfactory under the high-soot-load conditions.

Research on Back Pressure of Exhaust Gases for CMWF DPF

Study On Flow Resistance And Filtration Efficiency Of The Carbonized Micron Wood Fiber Dpf

Research on the Working Performance of Carbonized Micro-wood Fiber DPF

Research on the Exhaust Pressure Drop Gradient of Micro-Length Fiber Carbonized Wood DPF

Study on Test Instrument and Filtration Theory of the Carbonized Micron Wood Fiber Dpf

Experimental study on the relation between pressure drop and seepage velocity in carbonized microwood fiber DPF

Theoretical and Experimental Research on the Characteristics of Micro-Length Fiber Carbonized Wood DPF

Present Status and Development Trend of the Exhaust Particulate Filter for Diesel Vehicles

Lumped model for evaluating dynamic filtration and pressure drop behaviour in diesel particulate filters

Adsorption properties of carbonized micron wood fiber filter for nanoparticles emitted by engine

Study on the purification of diesel engine exhaust particles based on water film adsorption

Property Simulation and Test of Carbonized Micro-Wood Fiber Filter DPF Based on FLUENT

Performance Study about a New Kind Wood Fiber Filter Element Utilized in Capturing Diesel Particulate Material

Research on the filtration and regeneration of fuel borne catalyst diesel particulate filter of diesel engine

A Research on the Filtration and Regeneration of Fuel Borne Catalyst Diesel Particulate Filter of Diesel Engine

Study on the Exhaust Back-pressure Threshold-value MAP for the Diesel Particulate Filter Regeneration

Modeling of Soot Fragmentation That Proceeds in a Catalyzed Diesel Particulate Filter of a Diesel Engine

A Study on the Pressure Drop of Diesel Particulate Filter

Research on Influence of Exhaust Characteristics and Control Strategy to DOC-Assisted Active Regeneration of DPF

Study on Dynamic Response Characteristic of Back-Pressure Signal Acquisition System for Diesel Particulate Filter

Investigation of Diesel Particulate Filter Performance under Typical Failure Conditions