Abstract:Feedrate scheduling is one of the most important factors of computer numerical control (CNC) machining and has become a crucial research problem. In order to improve the machining accuracy and motion smoothness, an optimized feedrate scheduling method considering round-off error compensation based on S-shaped acceleration/deceleration (ACC/DEC) algorithm is proposed in this paper. There are two main stages, namely initial feedrate scheduling and parameters calculation of round-off error compensation. In the stage of initial feedrate scheduling, a novel time rounding principle is introduced to reduce the round-off error. Meanwhile, the motion parameters of each section can be calculated based on the proposed feedrate scheduling method. The constant feedrate section used for round-off error compensation is always guaranteed to exist although the actual maximum feedrate might be smaller than the command feedrate. Then, in the stage of compensation parameters calculation, the round-off error can be obtained based on the proposed time rounding principle and the scheduled parameters should be updated. In order to maintain the continuity of the acceleration profile, the improved trapezoidal ACC/DEC algorithm is introduced to conduct the error compensation and the crucial parameters can be calculated based on its special properties. In addition, the feedrate look-ahead strategy is also tweaked to enhance the reliability of feedrate scheduling. Finally, a series of simulations and practical experiments with two non-uniform rational B-spline (NURBS) curves are conducted to verify the good performance and applicability of the proposed method.

Predictive Force Model Based Variable Feedrate Scheduling for High-Efficiency NC Machining

Feedrate scheduling strategy for free-form surface machining through an integrated geometric and mechanistic model

A Feedrate Scheduling in Die-Cavity Roughing Based on Cutting Force Surface Model

A Feedrate Scheduling Strategy Based on A General Force Model

Mechanics-based Feedrate Scheduling for Multi-Axis Plunge Milling

An Intelligent Optimization Approach of Feedrate Scheduling Based on Hybrid Simulation Models

Feedrate optimization for variant milling process based on cutting force prediction

Adaptive feedrate scheduling for NC machining along curvilinear paths with improved kinematic and geometric properties

Study of Linear Feedrate Control in NC Machining

An Optimized Milling Force Prediction Method for Multi-Axis Ball-End Finish Milling

Feedrate Optimization Based on Load Control for Corner-milling

Optimization of Tool Geometry and Cutting Parameters Based on a Predictive Model of Cutting Force

Multi-constrained adaptive feedrate schedule strategy for complex curved surface machining

Adaptive Feedrate Planning on Parametric Tool Path with Geometric and Kinematic Constraints for CNC Machining

Feedrate Optimization for Worn Cutter with Measured Cutting Force in Rough Milling.

A Novel Automatic Feedrate Adjustment Method for Die-Cavity Roughing

An Optimized Feedrate Scheduling Method for CNC Machining with Round-off Error Compensation

A Force-Measuring-based Approach for Feed Rate Optimization Considering the Stochasticity of Machining Allowance

Adaptive Feedrate Interpolation with Multiconstraints for Five-Axis Parametric Toolpath

Off-Line Feed Rate Scheduling Using Virtual CNC

3d Surface Topography Simulation And Experiments For Ball-End Nc Milling Considering Dynamic Feedrate