Computational Fluid Dynamics Analysis and Verification of Hydraulic Performance in Drip Irrigation Emitters
Li Yongxin,Li Guangyong,Qiu Xiangyu,Wang Jiandong,Mahbub,Alam
2005-01-01
Abstract:The Computational Fluid Dynamics (CFD) method was applied to investigate the hydraulic performance of labyrinth type emitter. The characteristic of the emitter (COE), the relationship between the flow rate of the emitter and the pipe pressure, was numerically calculated using CFD model, and the standard k–εturbulence model was introduced in the calculation. The modeling results were compared with the laboratory test results. The CFD modeling results show a good correlation with measured results. The pressure and velocity distributions in the flow path of the labyrinth emitter were numerically simulated by the CFD method, and were compared to the pressure distribution obtained from a prototype of the emitter manufactured with the dimensional ratio of 10:1. Both modeling and the measured results indicated that the pressure was reduced linearly with the length of the emitter flow path. The CFD method was found to be an effective method to investigate the hydrodynamic performance of drip emitters. Introduction: The emitter is an important component in a drip irrigation system. As water flows into the emitter from the lateral pipe, the turbulent flow path of the emitter dissipates energy and thereby reduces pressure. Ordinarily, the emitter flowrate increases with the static pressure in a lateral pipe in an exponential relation (Karmelli, 1977). The relationship between the emitter flowrate and the static pressure of the pipe, which is called characteristic of emitters (COE), is very important to a drip irrigation system. This relationship is used in designing the desired emitter flow path. Computational Fluid Dynamics (CFD) numerical technique was applied to investigate the flow, heat and mass transfer for many years. CFD technique has many advantages compared with other numerical calculation methods. The simulation can maintain a stable boundary condition while CFD modeling can be easily simulated with the change of the structure specification (Lee and Short, 2000). The numerical calculation results can help researcher analyze the hydraulic performance of the emitters and modify the geometries of the flow path, thus reducing time and cost for producing new emitter designs (P. Salvador et al, 2004). The objective of this study was to apply the Computational Fluid Dynamics (CFD) numerical method to investigate the hydraulic performance of drip irrigation emitters, and to simulate the 1 Associate Professor, Department of Fluid Machinery & Fluid Engineering, China Agricultural University, Beijing 100083, China. 2 Professor, Department of Irrigation and Drainage Engineering, China Agricultural University, Beijing 100083, China. E-mail: lgyl@cau.edu.cn 3 Masters Candidate, Dept. of Irrigation and Drainage, China Agricultural University. 4 Masters Candidate, Dept. of Irrigation and Drainage, China Agricultural University. 5 Associate Professor, Biological and Agricultural Engineering, Kansas State University, Kansas, USA.