Abstract:The Computational Fluid Dynamics (CFD) method was applied to investigate the hydraulic performance of labyrinth type emitter. The characteristic of the emitter (COE), the relationship between the flow rate of the emitter and the pipe pressure, was numerically calculated using CFD model, and the standard k–εturbulence model was introduced in the calculation. The modeling results were compared with the laboratory test results. The CFD modeling results show a good correlation with measured results. The pressure and velocity distributions in the flow path of the labyrinth emitter were numerically simulated by the CFD method, and were compared to the pressure distribution obtained from a prototype of the emitter manufactured with the dimensional ratio of 10:1. Both modeling and the measured results indicated that the pressure was reduced linearly with the length of the emitter flow path. The CFD method was found to be an effective method to investigate the hydrodynamic performance of drip emitters. Introduction: The emitter is an important component in a drip irrigation system. As water flows into the emitter from the lateral pipe, the turbulent flow path of the emitter dissipates energy and thereby reduces pressure. Ordinarily, the emitter flowrate increases with the static pressure in a lateral pipe in an exponential relation (Karmelli, 1977). The relationship between the emitter flowrate and the static pressure of the pipe, which is called characteristic of emitters (COE), is very important to a drip irrigation system. This relationship is used in designing the desired emitter flow path. Computational Fluid Dynamics (CFD) numerical technique was applied to investigate the flow, heat and mass transfer for many years. CFD technique has many advantages compared with other numerical calculation methods. The simulation can maintain a stable boundary condition while CFD modeling can be easily simulated with the change of the structure specification (Lee and Short, 2000). The numerical calculation results can help researcher analyze the hydraulic performance of the emitters and modify the geometries of the flow path, thus reducing time and cost for producing new emitter designs (P. Salvador et al, 2004). The objective of this study was to apply the Computational Fluid Dynamics (CFD) numerical method to investigate the hydraulic performance of drip irrigation emitters, and to simulate the 1 Associate Professor, Department of Fluid Machinery & Fluid Engineering, China Agricultural University, Beijing 100083, China. 2 Professor, Department of Irrigation and Drainage Engineering, China Agricultural University, Beijing 100083, China. E-mail: lgyl@cau.edu.cn 3 Masters Candidate, Dept. of Irrigation and Drainage, China Agricultural University. 4 Masters Candidate, Dept. of Irrigation and Drainage, China Agricultural University. 5 Associate Professor, Biological and Agricultural Engineering, Kansas State University, Kansas, USA.

Study on Fluid Movement Characteristics inside the Emitter Flow Path of Drip Irrigation System Using the Yellow River Water

Dynamic Characteristics and Inducing Mechanism of Emitter Clogging in the Drip Irrigation System Using Yellow River Water

Application of Computational Fluid Dynamics to Design High Performance Drip Irrigation Emitters

Computational Fluid Dynamics Analysis and Verification of Hydraulic Performance in Drip Irrigation Emitters

Evaluations of Emitter Clogging in Drip Irrigation by Two-Phase Flow Simulations and Laboratory Experiments

Mechanism of Intermittent Fluctuated Water Pressure on Emitter Clogging Substances Formation in Drip Irrigation System Utilizing High Sediment Water

Effects of microorganisms on clogging process and clogging substances accumulation of drip irrigation emitters using the high-sediment water sources

Simulation of the Flow Characteristics of a Drip Irrigation Emitter with Large Eddy Methods.

Effect of Lateral Flushing on Emitter Clogging under Drip Irrigation with Yellow River Water and a Suitable Method

Numerical Simulation and Optimisation of the Inlet Structure of Dentiform Emitters in Drip-Irrigation Systems

Modeling of hydraulic characteristics through labyrinth emitter in drip irrigation using computational fluid dynamics

Anti-Clogging Evaluation for Drip Irrigation Emitters Using Reclaimed Water

Study of Hydraulic Performance of the Eddy Channel for Drip Emitters

Progress in measurement of hydrodynamic characteristics in drip irrigation emitters

Visualizing Particle Movement in Cylindrical Drip Irrigation Emitters with Digital Particle Image Velocimetry

Numerical Flow Simulation and Optimum Channel Design of Drip Irrigation Emitter

HYDRAULIC CHARACTERIZATIONS OF TORTUOUS FLOW IN PATH DRIP IRRIGATION EMITTER

CFD and Digital Particle Tracking to Assess Flow Characteristics in the Labyrinth Flow Path of a Drip Irrigation Emitter

Analysis of Tracing Ability of Different Sized Particles in Drip Irrigation Emitters with Computational Fluid Dynamics

Using Industrial Computed Tomography to Determine the Spatial Distribution of Clogging Substances in Drip Irrigation Emitter Flow Channels

Design and Numerical Simulation of the Headworks in the Shizuishan Section of the Yellow River