Abstract:The harsh operating environment of automotive and aerospace applications causes printed circuit board (PCB) connectors to be susceptible to intermittent high contact resistance, which eventually leads to a failure resulting in the loss of signal integrity. Pin fretting within the mating connector is often the cause of these failures. Over the past several years, there has been a significant increase in the laboratory-based testing of sample connectors for pin fretting. These laboratory-based results have shown the primary cause of pin fretting to be due to the relative motion within the mating connector. However, quantification of the relative motion in different vibration environments by considering the dynamics of PCBs has not been studied yet. This paper develops a new methodology for studying pin fretting within the mating connector. The developed methodology is based on the quantification of relative motion as a measure of pin fretting by considering the dynamics of PCBs, printed circuit board assemblies (PCBAs), and mounting brackets. To do this, a continuous, lightly damped, multi-degree of freedom (MDOF) model is developed for the assembly consisting of PCBs, PCBAs, and mounting brackets. The behavior of the system is investigated by exciting the system using harmonic and random vibration signals. In the harmonic signal analysis, a frequency domain-based approach is presented to compute the relative motion of the mating connector, while a pseudo-random time series signal derived from the power spectrum density (PSD) of the signal is used to excite the system for the random vibration excitation analysis. The relative response vector is then computed based on the system's response. The results of the relative motion of the mating connectors are presented in terms of the maximum amplitude of relative motion and the cumulative relative movement. The significance of the cumulative relative movement is that the complex phenomenon of pin fretting in the mating connectors can be represented by a simple time series model that can be used to correlate the material degradation. Finally, two numerical examples using the analytical and finite element-based (FE) technique are shown to demonstrate the proposed methodology. The examples show that the method proposed here is systematic and constructive in quantifying the pin fretting behavior.

Modal Analysis Of Board-Level Electronic Package

Dynamic Response of a Board-Level Electronic Package under Drop Impact Load

Board Level Drop Test Analysis Based on Modal Test and Simulation

Dynamic Substructure Method for Prediction of Solder Joint Reliability of IC Package under Drop Test

Failure Analysis of Board-Level Sn-Ag-Cu Solder Interconnections under JEDEC Standard Drop Test

Finite element model verification for packaged printed circuit board by experimental modal analysis

Board-Level Drop Impact Reliability Analysis of Dual-Side Molding System-in- Package (SiP) Modules

Modal Analysis of the Printed Circuit Board Based on Finite Element Method

Printed-Circuit Board Model Establishment and Solder Joint Failure Analysis

Influence of Printed Circuit Board Dynamics on the Fretting Wear of Electronic Connectors: A Dynamic Analysis Approach

Understanding board level vibrations in automotive electronic modules

Viscoelastic Influence on Dynamic Properties of PCB under Drop Impact

Modal Test and Analysis of Electronic Cabinet

Modeling and Simulation of PCB Assembly under Board-Level Drop Impact

Analysis of Smt Decoupling Capacitor Placement in Electronic Packages Using Hybrid Modeling Method

Experimental and numerical analysis of BGA lead-free solder joint reliability under board-level drop impact

Effect of Nonlinear Interactions of Electronic Assemblies in Response to Multiaxial Vibration

Study on Board Level Drop Reliability of Wafer Level Package

Reliability Analysis and Structural Optimization of Circuit Board Based on Vibration Mode Analysis and Random Vibration

Failure and Failure Characterization of QFP Package Interconnect Structure under Random Vibration Condition.

Modeling of board-level package by Finite Element Analysis and laser interferometer measurements