Abstract:High-temperature superconductor (HTS) coated conductors (CC) are often wound into pancake coils with electrical insulation in-between the turns. The copper terminals are used for current injection and conduction cooling. An inherent variation of the critical current along the CC length results from its manufacturing process. This variation causes non-uniform heat generation, particularly when the coil is operated at a high fraction of the nominal critical current or when large critical current defects are present. The temperature distribution resulting from the balance between cooling and heating, in combination with the magnetic field and critical current distributions, determines whether a thermal runaway occurs. Accurately predicting the level of critical current defects that can be tolerated during conduction-cooled operation is difficult and requires a 3D coupled electromagnetic and thermal simulation. This paper presents the results of simulations that are performed with the open-source Finite Element Quench Simulator (FiQuS) tool developed at CERN as part of the STEAM framework. The 3D coupled magnetodynamic-thermal simulations are based on the H-phi formulation and use thin shell approximations, a CC homogenization and conduction-cooling. The critical current (Ic) is varied along the CC length. The effect of a single defect specified as a reduction of Ic along the CC length is investigated in terms of the coil's ability to reach and maintain the operating conditions. The Ic and length of the defect that results in a thermal runaway are analyzed in terms of defect location. In addition, a classical 1D scenario with a quench heater is studied. Both the local defect and the heater cases are compared in terms of the voltage signal available for quench detection. These cases result in very different requirements for quench detection, and their implications are discussed.

Fault Tolerant Superconducting Busbar With Reduced Self-Field Effect on Critical Current Design for All Electric Aircraft

HTS Cable Design for Aircraft Application Considering Fault Conditions

Pole-to-Pole Fault Management for Electric Aircraft DC Network with HTS Cables

AC transport loss analysis of HTS stack busbars for all-electric aircraft with harmonics and DC offset considerations

Simulation Analysis of DC Fault Interruption Characteristics of Superconducting Electric Aircraft Propulsion

No-Insulation High-Temperature Superconductor Winding Technique for Electrical Aircraft Propulsion

Feasibility Analysis on Cryogenic Properties of Supercritical Nitrogen to be used in the Cooling of Hg-Based High Temperature Superconductors for Electric Aircraft Propulsion

Design Study for a Superconducting High-Power Fan Drive for a Long-Range Aircraft

Design And Test Of High-T-C Superconducting Coils For A Three-Phase 10.5 Kv/1.5 Ka Fault Current Limiter

High Temperature Superconducting Cables and their Performance against Short Circuit Faults: Current Development, Challenges, Solutions, and Future Trends

A Fault Protection Strategy Based on Z-Source Solid State Circuit Breaker for More Electric Aircraft

Fully superconducting machine for electric aircraft propulsion: study of AC loss for HTS stator

Temperature Analysis of HTS Cables in Superconducting DC Energy Pipeline During Short-circuit Fault

Electromagnetic Shielding Technique for No-insulation Superconducting Rotor Windings in Electrical Aircraft Propulsion

Influence of Critical Current Distribution on Operation, Quench Detection and Protection of HTS Pancake Coils

Dynamic Experiment For The Magnetothermal Stability Of A 110 Kv/3 Ka Cold Dielectric High-Temperature Superconducting Cable With An Impact Of Fault Current In Power System

Progress in high temperature superconductor coated conductors and their applications

High Voltage Calculations for a 380 kV Superconducting Fault Current Limiter

Design and Performance Tests of a Fault Current-Limiting-Type Tri-Axial HTS Cable Prototype

Effect of Arc Chute on DC Current Interruption by Liquid Nitrogen in HTS Electrical System of Distributed Propulsion Aircraft

Feasible and Optimal Design of an Airborne High-Temperature Superconducting Generator Using Taguchi Method