Abstract:This paper presents a study of the current carrying capacity and AC loss of high-temperature superconducting (HTS) stacks to be used in busbar applications for all-electric aircraft. A 2D model was developed using COMSOL Multiphysics with a T-A formulation for detailed analysis. The study began by applying a stable 20 kA DC offset current to the HTS stacks, to simulate practical operating conditions. Firstly, the behaviour of the critical current was studied under self-field conditions for stacks with different number of HTS tapes and spacing. Secondly, AC ripple currents were introduced together with DC offsets and the effects of 3rd and 5th harmonic distortions (HD) were studied. The results show that configurations with 40 tapes and gaps of more than 2 mm are considered suitable for safe current transport under DC conditions. On the other hand, increasing the tape spacing leads to an increase in the safe transport current ripple, due to the reduced magnetic field interaction within the stack. In addition, the transport loss decreases as the air gap increases due to the reduction in the self-field, whereas it increases as the number of strips increases. The influence of the 3rd HD on the transport loss is minimal at a ripple current of 1% and slightly noticeable at 2%. However, it becomes more obvious as the ripple current approaches the critical value. Remarkably, even cases with equivalent total harmonic distortion (THD) show significantly higher transport losses when characterised by higher 5th HD than their counterparts with 3rd HD. This comprehensive analysis provides valuable information on the performance characteristics of HTS stacks in all-electric aircraft busbar applications and offers important insights for the development and optimisation of these systems in practical aerospace applications.

Pole-to-Pole Fault Management for Electric Aircraft DC Network with HTS Cables

HTS Cable Design for Aircraft Application Considering Fault Conditions

Fault Tolerant Superconducting Busbar With Reduced Self-Field Effect on Critical Current Design for All Electric Aircraft

A Review on Insulation and Dielectrics for High- Temperature Superconducting Cables for Power Distribution: Progress, Challenges, and Prospects

Modeling and Analysis of DC Pole-to-Pole Fault in High-Frequency-Bus Based Power Electronic Transformer

Transient Analysis of HVDC HTS Cable in Power Grid Using Discretized Electrical-Thermal Model

Fault Characteristic Analysis and a Novel Pilot Protection Scheme for Pole-to-Ground Fault in Flexible DC Distribution Network

Flexible DC System Fault Analysis

Fault Tolerant Control of Advanced Power Generation Center for More-Electric Aircraft Applications

Fault-Tolerant Architectures with Enhanced Bus Protection for Electric/Hybrid Aircraft Systems

Analysis of DC Pole-to-Pole Fault for Converters in MVDC Shipboard Power System

No-Insulation High-Temperature Superconductor Winding Technique for Electrical Aircraft Propulsion

High Temperature Superconducting Cables and their Performance against Short Circuit Faults: Current Development, Challenges, Solutions, and Future Trends

AC transport loss analysis of HTS stack busbars for all-electric aircraft with harmonics and DC offset considerations

A novel voltage projection component-based protection scheme for hybrid multi-terminal HVDC transmission lines

Analysis of Armature Inter-Turn Fault in the Multiphase Synchronous Generator-Rectifier System

Fault-tolerant hierarchical energy management system for an electrical power system on more-electric aircraft

A Faulty Pole Detection Method for the VSC-HVDC System Based on the Aperiodic Component Energy

Analysis and Enhanced Control of Hybrid-MMC-Based HVDC Systems During Asymmetrical DC Voltage Faults

Electromagnetic Shielding Technique for No-insulation Superconducting Rotor Windings in Electrical Aircraft Propulsion