Enhancing Quality Control: Image-Based Quantification of Carbides and Defect Remediation in Binder Jetting Additive Manufacturing

Amit Choudhari,James Elder,Manoj Mugale,Sanoj Karki,Satyavan Digole,Stephen Omeike,Tushar Borkar
DOI: https://doi.org/10.3390/ma17102174
IF: 3.4
2024-05-07
Materials
Abstract:While binder jetting (BJ) additive manufacturing (AM) holds considerable promise for industrial applications, defects often compromise part quality. This study addresses these challenges by investigating binding mechanisms and analyzing common defects, proposing tailored solutions to mitigate them. Emphasizing defect identification for effective quality control in BJ-AM, this research offers strategies for in-process rectification and post-process evaluation to elevate part quality. It shows how to successfully process metallic parts with complex geometries while maintaining consistent material properties. Furthermore, the paper explores the microstructure of AISI M2 tool steel, utilizing advanced image processing techniques like digital image analysis and SEM images to evaluate carbide distribution. The results show that M2 tool steel has a high proportion of M6C carbides, with furnace-cooled samples ranging from ~2.4% to 7.1% and MC carbides from ~0.4% to 9.4%. M6C carbides ranged from ~2.6% to 3.8% in air-cooled samples, while water-cooled samples peaked at ~8.52%. Sintering conditions also affected shrinkage, with furnace-cooled samples showing the lowest rates (1.7 ± 0.4% to 5 ± 0.4%) and water-cooled samples showing the highest (2 ± 0.4% to 14.1 ± 0.4%). The study recommends real-time defect detection systems with autonomous corrective capabilities to improve the quality and performance of BJ-AM components.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering
What problem does this paper attempt to address?
The problems that this paper attempts to solve mainly focus on improving the quality control of Binder Jetting (BJ) Additive Manufacturing (AM). Specifically, the research focuses on the following aspects: 1. **Defect analysis and identification**: The research explores the common defect types and their formation mechanisms in the BJ - AM process. These defects include but are not limited to deformation, rough surface, and low dimensional accuracy. By systematically studying these defects, it aims to provide effective quality control strategies. 2. **Defect mitigation strategies**: In response to the identified defects, the paper proposes specific solutions to reduce or eliminate the impact of these defects on the performance of the final product. This includes a real - time defect detection system during the printing process and post - processing evaluation methods to improve the quality and performance of parts. 3. **Material property optimization**: The research also pays special attention to the microstructure characteristics of AISI M2 tool steel in the BJ - AM process, especially the distribution of carbides (such as M6C and MC carbides). Through advanced image processing techniques (such as digital image analysis and Scanning Electron Microscopy (SEM) imaging), the paper evaluates in detail the percentage and distribution of carbides under different cooling conditions, as well as the influence of sintering conditions on the shrinkage rate. 4. **Process parameter optimization**: In order to improve the overall quality and performance of BJ - AM parts, the paper also explores how to control and improve material properties by optimizing process parameters (such as curing temperature, degreasing temperature, sintering temperature, etc.). In summary, the main objective of this paper is to improve the quality control level of binder jetting additive manufacturing by in - depth research on the defects in the BJ - AM process and their mitigation strategies, as well as by quantifying and optimizing material properties, thereby promoting the wider application of this technology in industrial applications.