Abstract:The foreseen upgrade of the LHC to its high luminosity phase (HL-LHC), will maximize the physics potential of the facility. The upgrade is expected to increase the instantaneous luminosity by a factor of 5 and deliver an integrated luminosity of 3000 fb-1 after 10 years of operation. As a result of the corresponding increase in radiation and pileup, the electromagnetic calorimetry in the CMS endcaps will sustain maximum integrated doses of 1.5 MGy and neutron fluences above 1e16 neq/cm2, necessitating their replacement for HL-LHC operation. The CMS collaboration has decided to replace the existing endcap electromagnetic and hadronic calorimeters by a High Granularity Calorimeter (HGCAL) that will provide unprecedented information on electromagnetic and hadronic showers in the very high pileup of the HL-LHC. In order to employ Si detectors in HGCAL and to address the challenges brought by the intense radiation environment, an extensive R&D program has been initiated, comprising production of prototype sensors of various types, sizes and thicknesses, their qualification before and after irradiation to the expected levels, and accompanying simulation studies. The ongoing investigation presented here includes measurements of current-voltage and capacitance-voltage characteristics, along with predicted charge collection efficiences of the sensors irradiated to levels expected for the HGCAL at HL-LHC. The status of the study and the first results of the performance of neutron irradiated Si detectors, as well as their comparison with numerical simulations, are presented.

Performance of H2GCROC3, the readout ASIC of SiPMs for the back hadronic sections of the CMS High Granularity Calorimeter

Application of the VMM ASIC for SiPM-based calorimetry

First test results of the HGCAL concentrator ASICs: ECON-T and ECON-D

The CMS High-Granularity Calorimeter for Operation at the High-Luminosity LHC

Study of SiPM for CEPC-AHCAL

A Novel High Dynamic-Range SiPM for Scintillator-Based Hadronic Calorimetry

Two HVCMOS active pixel ASIC designs for the Measurement of GCR and SEP with a combined dynamic range of >80 dB

The Silicon Sensors for the High Granularity Calorimeter of CMS

Performance of a Highly Granular Scintillator-SiPM Based Hadron Calorimeter Prototype in Strong Magnetic Fields

Silicon Photomultiplier Readout System for the ECAL in the PEBS and Test Results from the System

Silicon sensors for the CMS HGCAL upgrade: Challenges, sensor design & electrical characterization

The AMS Silicon Tracker Readout: Performance Results with Minimum Ionizing Particles

PARISROC, a Photomultiplier Array Integrated Read Out Chip

A Highly Linear FPGA-Based TDC and a Low-Power Multichannel Readout ASIC with a Shared SAR ADC for SiPM Detectors

Experimental and simulation study of irradiated silicon pad detectors for the CMS High Granularity Calorimeter

A mixed-signal ASIC for the readout of Gas Electron Multiplier detectors design review and characterization results

Design and performance of the silicon sensors for the CMS barrel pixel detector

The Development of a Readout ASIC for TPC Based X-ray Polarimeter

Casca: A Readout Asic For A Tpc Based X-Ray Polarimeter

Performance study of SKIROC2/A ASIC for ILD Si-W ECAL