Abstract:Due to the occurrence of earth tremors which leads to the vibrations of foundations and perhaps failure of buildings and roads, it is therefore important to understand and have knowledge of the geomechanical soil properties for foundation design, assessment of risks and suggestion of mitigation plans in engineering structures and road construction. A total of 3 boreholes were drilled with the Standard Penetration Test (SPT) performed and Downhole Seismic Test (DST) carried out in the boreholes located within Assa to investigate the Geomechanical soil properties in the area. For the geophysical survey, the downhole seismic test was carried out to determine the P-wave and S-wave. The results were processed using the generalized reciprocal method (GRM) with the Seisimager program. The results of soil dynamic modulus (shear, young and bulk modulus) and Poisson ratio recorded from DST conducted in BH1, BH2 and BH3 ranges from 7300 KPa to 72390 KPa, 0.31 to 0.41 for the Poisson ratio. Meanwhile, soil static modulus and Poisson’s ratio recorded from SPT conducted in BH1, BH2 and BH3 ranges from 2520 to 44687.0 KPa, 0.20 to 0.55 for the Poisson ratio respectively. The results of this study have shown that there is a wide variation between geomechanical properties derived from geotechnical investigations (static properties) and geophysical investigations (dynamic properties). Based on depth trend analysis, the dynamic and static soil elastic properties all increases with depth. Generally, the dynamic soil properties were significantly higher than the static elastic properties. At shallow depths (<12.0 m), the difference between static and dynamic soil modulus was relatively small, but increased with increasing depth. Meanwhile, the difference between static and dynamic Poisson ratio was high at shallow depth and it decreased with increased depths where they almost overlap. Correlation between the derived static and dynamic properties all revealed positive correlation trends. The strength of the correlation was highest for young modulus (r=0.87) which was closely followed by the shear modulus (r=0.63). Meanwhile, Poisson ratio (r=0.40) and bulk modulus (r=0.23) revealed weak positive correlation trends. The regression models generated from this study were used to derive static elastic properties and compared with the static properties obtained from geotechnical investigation thereby deriving the equations Dynamic Shear Modulus = (1.4207 x Static Shear Modulus) + 5022, Dynamic Young Modulus = (2.0241 x static young modulus) + 5054.8, Dynamic Bulk Modulus = (1.7852 x static bulk modulus) + 15458, Dynamic Poisson’s ratio = (0.1812 x Static Poisson’s ratio) + 0.3154. The results showed fairly good match between static (geotechnical) shear modulus and static (from regression model) shear modulus, static (geotechnical) young modulus and static (from regression model) young modulus. There was no good match obtained for bulk modulus and Poisson ratio generally, except at shallow depth (< 12 m depth) where Poisson ratio revealed a good match.

Comparison of pressuremeter and plate loading results to determine the deformation modulus in fine-grained soil

Large-Deformation Finite-Element Simulation of Deformation and Strain Fields Resulting from Closed-End Displacement Pile Installation in Sand

A New Index for Evaluating Liquefaction Resistance of Soil under Combined Cyclic Shear Stresses

Study of Equivalent Elastic Parameters of Composite Foundations

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

Experimental Study Of Correlation Of Dynamic Compaction For Foundation Backfilled With Crushed Stone

Quantification of the Soil Stiffness Constants Using Physical Properties of Paddy Soils in Yangtze Delta Plain, China

Relationship Between Cell-Indicated Earth Pressures and Field Earth Pressures in Backfills

A Destructive Field Study on the Behavior of Pile under Ten

The new empirical formula based on dynamic probing test results in fine cohesive soils

Estimating Penetrometer Resistance and Matric Potential from the Velocities of Shear and Compression Waves

Effect of Large Deformation Analysis for Site Investigation Tool - CPT in Layered Soils

COMPARATIVE ANALYSIS OF STATIC SHEAR MODULUS AND DYNAMIC SHEAR MODULUS DETERMINED BY GEOPHYSICAL AND GEOTECHNICAL INVESTIGATION

Comparison of indentation test results and well-logging data for estimation of uniaxial compressive strength and Young's modulus

Experimental Evaluation of the Effects of Structural Parameters, Installation Methods and Soil Density on the Micropile Bearing Capacity

Numerical investigations into cycling of full-flow penetrometers in soft clay

Comparative study on the deformation moduli of roadway surrounding rock in coal mines: a case study

Contact stiffness parameters of soil particles model for discrete element modeling using static packing pressure test

Elastic Stiffness Modelling of Opalinus Clay Based on Laboratory Measurements with Implications for In-situ Testing

Numerical Evaluation of Dynamic Earth Lateral Pressure on Basement Walls in Cohesionless Soils (A Case Study of Iranian Earthquakes)