Abstract:In this work, investigations of the magnetic microstructure of anisotropic sintered SmCo5 permanent magnets with high coercivity have been made using the colloid-scanning electron microscopy (SEM) technique and magnetic force microscopy (MFM). The magnets were produced by powder metallurgy (sintering) process and consisted of oriented grains with an average size of about 20μm. They were studied in the thermally demagnetized state. Owing to the application of digital image recording, enhancement and analysis, high-quality images of the magnetic microstructure were obtained and analyzed not only qualitatively but also quantitatively. Improvements over previous results were achieved. The grains show the presence of magnetic domains, as expected. At the surface perpendicular to the alignment axis, the coarse domain structure in the form of a maze pattern with surface reverse spikes is observed. The main (maze) domains had typical widths 3–5μm. The reverse spike domains were imaged as circles typically 1–2μm in diameter or as elongated regions up to about 6μm in length. Interestingly, in addition to the coarse maze domains and reverse spikes near the surface, a fine surface domain structure is revealed with MFM. The fine scale domains are found to be magnetized perpendicular to the surface and their occurrence is attributed to further reduction of the magnetostatic energy at the cost of a larger domain wall energy. On the surface parallel to the alignment axis, the main domains within individual grains are imaged as stripe domains with domain walls running approximately parallel to the alignment axis, while reverse spike domains are displayed in the form of triangular domains and occur near some grain boundaries, pores or precipitations. The magnetic alignment of grains was found to be good, but certainly not perfect. In most cases the domain structures within grains were independent of their neighbors, but in some cases (not so rare) observations indicated the existence of significant magnetostatic coupling between neighboring grains. The main and surface domain widths were determined by digital means using the stereologic method of Bodenberger and Hubert. Moreover, the domain wall energy and other intrinsic parameters for the studied magnets were determined.

Study of magnetization reversal and magnetic hardening in SmCo 5 single crystal magnets

Coercivity mechanism of high-performance anisotropic heterostructure SmCo 5 magnets

Quantitative analysis of pinning-hardened intrinsic coercivity of Sm(CoFeCuZr)z (z = 7.0–7.8) high-temperature permanent magnets

Microstructural Characterization of Sm-Co Magnets

Understanding of magnetization reversal mechanism of precipitation-hardening samarium-cobalt magnets from micromagnetic simulation

Studies of the domain structure of anisotropic sintered SmCo5 permanent magnets

Unconventional magnetization textures and domain-wall pinning in Sm-Co magnets

Strategy of preparing SmCo based films with high coercivity and remanence ratio achieved by temperature and chemical optimization

Quantitative analyses of surface and bulk magnetization in Nd2Fe14B and SmCo5 single crystals: towards understanding the large N eff in nucleation-type magnets

High coercivity SmCo5 synthesized with assistance of colloidal SiO2

Strategies for the Synthesis of Nanostructured SmCo 5 Magnetic Particles for Permanent Magnetic Application

Influence of amorphous phase on coercivity in SmCo5-Cu nanocomposites

Dispersible SmCo5 nanoparticles with huge coercivity

Atomic-scale structure clarification of the planar Z phase and its influence on the magnetic properties in Sm(CoFeCuZr) permanent magnets

Revisiting the Structural and Magnetic Properties of SmCo5/Sm2Co17 Interface from First-Principles Investigations

Phase separation and chemistry evolution in Fe-rich Sm(CobalFe0.31Cu0.07Zr0.025)7.7 magnets: The effect of initial defect

First principles study of transition-metal substitutions in Sm–Co permanent magnets

Effect of interfacial stress on microchemistry and coercivity in 2:17-type SmCo sintered magnets

Atomic‐Scale Transition Zones Determined Coercivity in Samarium‐Cobalt Based Permanent Magnets

Microstructure and magnetic properties of SmCo5 sintered magnets

Enhancing ferromagnetism in the Sm(Co, Mn) 5 system: impact on phase stability and magnetic properties